Golden Lighting 8063-15L BUS User Manual

A

Fixture

Ground wire
Lock

Screw

Safety cable

Hickey

Ceiling loop

Lock collar

1/4 IPS PIPE

(NOT PROVIDED)

Outlet box

Fixture wires

Hex wires

Nipple

Washer

Canopy

Lock Link

Chain

Lock Link

Lighting Fixture ITEM#: 8063-15L BUS
Installation Instruction

Warning

Before installing fixture, be sure the electricity to the wires you are working
with is shut off--either by removing the fuse or by setting the circuit breaker
off.

General Information

You don’t need special tools to install this fixture. Be sure to follow the steps
in the order given.
Under no circumstances should the fixture be hung on house el ectrical
wires. The fixture must be installed by means of sup port that is independent
of the outlet box. A swag type fixture should not be installed on a ceiling
which contains a radiant type heating system.
Remember that a fuse or circuit breaker protects wires from becoming
overheated. Overheated wires created an overload and cause the fuse to
blow or the circuit breaker to trip should such an event occur, replace the
fuse, or reset the circuit breaker, locate a nd correct the cause of the
overload--usually too many appliances on the same line or a short circuit.
Before tracing the wires for a short circuit, be sure to shut off the electri city
at the main switch.
If you must replace a blown fuse be sure to replace it with one rated for the
ampere capacity the circuit. For example, if a 15--AMP fuse blows, do not
replace it with a 30--AMP fuse.
Use only one hand to screw out a fuse, and keep your other hand away from
the wall or any other object, while you are touching the fuse.

Assembly the fixture

Carefully remove the fixture from the carton and check that all parts are
included, as shown in figure 1. Be careful not to inisplace any of the screws
or wire connectors which are needed for installing the fixture.

1.As shown in figure 1. Suggested installation.
Provide a 1/4 IPS pipe with one and secure mounted to a beam or a
structural member. The other end should protrude through the center or the
outlet box as shown.

ssembly the ceiling loop, nipple, nuts, and hickey to center 1/4 IPS support
pipe and adjust overall length to allow the ring to hold the canopy flush to the
ceiling. When the adjustments have been completed, secure the three (3)
nuts, as shown.
Attach the chain to the fixture loop. Slip the lock collar and canopy over the
upper end of the chain, loose the lock link to connect to the end link of chain
with the fixture loop and hang the fixture on the loop at the ceiling. Secure
the lock link.
Lace the fixture wires, ground and safety cable through the chain and loop,
exiting through the side of hickey. Place the safety cable through the lock
and coil the hickey twice in circle, through the top of the outlet box and
secure to structural member.

2. Installed properly rated light bulbs.
Your installation is now complete. Return power to the junction box and test
the fixture

SAFETY CABLE INSTALLTION INSTRUCTION

IMPORTANT: FOR A SAFE AND
SECURE INSTALLTION, THESE
FIXTURES MUST BE INSTALLED
BY MEANS OF SUPPORTS THAT
ARE INDEPENDENT OF THE
OUTLET BOX.

1. Loosen the lock screw and take
out the safety cable.

2. Lace the safety cable and
fixture wires through the chain
and canopy, exiting through the
side of crossbar.

3. Place the safety cable through
the lock, through the lock again;
tightens it with screw into lock.
Run cable through the top of
the outlet box and secure to
structural member before
connecting the wires.

CSKLG001