Golden Lighting 7509-9 PW User Manual

Fig 1

F

Read and review installation instruction sheet

ASSEMBLING THE FIXTURE (Fig.1)

NOTE: INSTALL THE GLASS ASSEMBLY

AFTER THE FIXTURE IS HUNG.

PARTS & ASSEMBLY SHEET

Notice:

parts.

Company Name:_______________________Co. Account #:____________

Fixture Name: Asteria 7509-9 PW

This fixture assembled PO:__________ Date: ________

Please review the parts listing and check for all parts before assembling the fixture. If any parts are

missing or damaged, please note onthis sheet and contact the place of purchase to arrange for replacement

PARTS LIST

Canopy Mounting Screws Top loop

1ea ∅5-1/2"*H1" 2ea 8#32-IP*1" 1ea 50MM*H60mm

Chain Wire connectors Nipple

1ea 6ft ∅4.2 3ea P3 Orange 1ea 1/4-IP*H60mm

Chain connector

2ea ∅5.8*H61mm 1ea ∅1-1/8"*H42mm 1ea W4-1/8"*E1"*H5mm

Hex Nut

1ea 1/8-IP*H4mm

Part Needed Quantity
Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments

to be filled out by retailer

Canopy loop
with Collar

Bulb

9ea G9*40W

Mounting strap

IXTURE ASSEMBLY INSTRUCTIONS

before assembling the fixture.

1. Gently spread the arms until evenly spaced if arms

are packed closed

For Customer Service, contact the place of purchase to arrange for replacement parts.

Copy of Instruction sheet for 7509(De Gao)-131115

7509-9 PW

ASSEMBLING THE FIXTURE (Fig.2)

2. Feed the fixture wires through Top Loop (J) and pull

to open one link of Chain (C2) then remove the excess

Fig 2

Fig 3

Fig 4

the wires until taut.

PARTS & ASSEMBLY SHEET

Fixture Name: Asteria 7509-9 PW

3. Then screw Top Loop (J) to the threaded center
column of Frame (M) until tight.

4. By measuring, determine correct number of links
needed for proper hanging height. Use a pair of pliers

Chain (C2) and discard it.

5. Use one Chain Connector (E2) to attach one end of
the chain to the Top Loop (D2) and close the chain
connector.

6. Feed the fixture wires through the Chain (every
three links) and pull the wires until taut.

7. Slip Canopy Loop Collar (B2) over the chain, then
do the same with the canopy (F2).

8. When ready to complete the installation Use the
other chain connector and attach the other end of the
chain to the Canopy Loop (A2) and close the chain
connector.

9. Make sure the weight of the chandelier will be
supported by the chain-not the electrical wire.
* You may now install the fixture.

Note: Complete these remaining steps after the
fixture is hung.

10. Pour crystals (Y) into the groove of Glass Shade
(O) then
place Glass Shades (O) over threaded Sockets (P).
Secure Glass Shades (O) by threading
Socket Rings (N) until tight.

11. Install the light bulbs in accordance with the
fixture's
specifications.
Bulb note: Use a tissue or paper towel to hold the
bulb and push down into the socket. Oils or dirt can
cause the bulb life to shorten. Rubbing alcohol is
recommended to clean the bulbs if dirty.
(DO NOT EXCEED MAXIMUM WATTAGE RATING)

For Customer Service, contact the place of purchase to arrange for replacement parts.

Copy of Instruction sheet for 7509(De Gao)-131115