Golden Lighting 7158-5 PWRBZ User Manual

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

PARTS & ASSEMBLY SHEET

Company Name:_______________________Co. Account #:_____________

to be filled out by retailer

Read and review installation instruction sheet before
assembling the fixture.

Fig. 1

For Customer Service, contact the place of purchase to arrange for replacement parts.

Fixture Name: Accurian 7158-5 PW/RBZ

This fixture assembled PO:__________ Date: ________

Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or

damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts.

PARTS LIST

Canopy Wire connectors Top loop

1ea @5"X1" 3ea P3 Orange 1ea 80X38X26mm

Chain

1ea 6ft x3.8mm 2ea 8/32" x 1" 1ea Φ15X3mm

Chain connector Hex Key

2ea @4X55mm 1ea Φ23X42.4mm 1ea

Mounting Strap
w/ ground screw

1ea 100X20X4.5mm 2ea @3/8 x 4mm

Part Needed Quantity

Junction Box
Screw

Canopy Loop
with Collar

Hex Nut Socket tool

Spring Washer

1ea

FIXTURE ASSEMBLY INSTRUCTIONS

7158-5 PW/ RBZ

ASSEMBLING THE FIXTURE (Fig. 1)

1. Gently spread the arms until evenly spaced if arms are
packed closed.

2. Thread the fixture Center column (T) into the housing
nipple (S).

NOTE: INSTALL THE GLASS ASSEMBLY AFTER THE
FIXTURE IS HUNG.

Fig 2

D

C

A-A'

PARTS & ASSEMBLY SHEET

Fixture Name: Accurian 7158-5 PW/RBZ

3. Slide the Decorative Rods (R) into the bracket on
Arms (V),and tighten the Screws (U) with Hex Key (O)
(See Detail: A-A")

4. Insert the Decorative Rods (R) into the holes on Top
cap housing (M). Turn housing to one side to allow
easier access, turn back to secure rods in place

5. By measuring determine correct number of links
needed for proper hanging height. Use a pair of pliers
to open one link of the Chain (K) then remove the
excess Chain (K) and discard it.

6. Use one chain connector (L) to attach one end of the
chain to the Top loop (J) and close the chain connector.

7. Feed the fixture wires through the Chain (every three
links) and pull the wires until taut.

8. Slip Canopy loop collar (H) over the chain, then do
the same with the canopy (G).

9. When ready to complete the installation Use the
other chain connector and attach the other end of the
chain to the canopy loop (F) and close the chain
connector.

10. Make sure the weight of the chandelier will be
supported by the chain-not the electrical wire.

* You may now install the fixture. Note: Complete
these remaining steps after the fixture is hung.

11. Slide Glass Shade (P) onto Threaded Socket (Q).
and secure the Glass Shade (P) by using Socket Tool (W)
to thread Socket Ring (N) to Socket tightly.

12. Install the light bulbs in accordance with the
fixture's specifications.

(DO NOT EXCEED MAXIMUM WATTAGE RATING) )

For Customer Service, contact the place of purchase to arrange for replacement parts.

A-A'