Golden Lighting 6005-ND3 RBZ User Manual

Canopy Wire connectors Top loop

1ea 5" X 1" 2ea P3 Orange 1ea 3/8 x 66mm

Chain

Junction Box
Screw

Socket Washer

1ea 6ft x 3.8mm 2ea 8/32" x 1" 5ea ~58 x 1mm

Chain connector Nipple

2ea 4 X 55mm 1ea 3/8 x 30mm x 5mm 1ea 3/8 x 45mm

Mounting Strap Hex Nut Srping Washer

1ea 3/4" X 4"

2ea 3/8 x 3mm 1ea 15 x 3mm

Socket Ring
(AB only)

Socket Ring
(PW, RBZ only)

Green Ground
Screw

3ea 51 x 23mm 3ea 50 x 9mm

1ea 8/32" X 10mm

Part Needed Quantity

Part Needed Quantity

Reason why (missing, scratched, broken glass, bent, bad finish)

Comments

ASSEMBLING THE FIXTURE (Fig. 1)

1. Feed the fixture wires through the Top Loop (J) and pull
the wires until taut.

2. Then screw the Top Loop (J) to the threaded center
column of Frame (M) until tight.

3. Gently spread the arms until evenly spaced if arms are
packed closed.

Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or

damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts.

PARTS LIST

Company Name:_______________________Co. Account #:_____________

to be filled out by retailer

For Customer Service, contact the place of purchase to arrange for replacement parts.

PARTS & ASSEMBLY SHEET

6005-ND3

Read and review installation instruction sheet before
assembling the fixture.

FIXTURE ASSEMBLY INSTRUCTIONS

This fixture assembled PO:__________ Date: ________

Fixture Name: Lancaster 6005-ND3 PW/RBZ/AB

Canopy Loop
with Collar

Fig. 1

NOTE: INSTALL THE GLASS ASSEMBLY AFTER THE
FIXTURE IS HUNG.

D

C

6005-ND3PartsInstallation_111004m.xls Page 1

Fixture Name: Lancaster 6005-ND3 PW/RBZ/AB

For Customer Service, contact the place of purchase to arrange for replacement parts.

7. Slip Canopy Loop Collar (H) over the chain, then do the
same with the Canopy (G).

8. When ready to complete the installation, use the
remaining chain connector and attach the loose end of the
chain to the Canopy Loop (F). Close the chain connector.

9. Make sure the weight of the chandelier will be supported
by the chain - not the electrical wire.

* You may now install the fixture.

4. By measuring, determine correct number of links needed
for proper hanging height. Use a pair of pliers to open one
link of the Chain (K) then remove the excess Chain (K) and
discard it.

5. Use a chain connector (L) to attach one end of the chain
to the Top Loop (J) and close the chain connector.

6. Feed the fixture wires through the Chain (every three
links) and pull the wires until taut.

Fig. 2

Note: Complete these remaining steps after the fixture is
hung.

10. Place the Glass Shades (O) over the Threaded Sockets
(N). Secure the Glass Shades (O) by threading the Socket
Rings (Q) over the socket washers (P) until tight.

11. Install the light bulbs in accordance with the fixture's
specifications.

(DO NOT EXCEED MAXIMUM WATTAGE RATING)

PARTS & ASSEMBLY SHEET

D

C

D

C

6005-ND3PartsInstallation_111004m.xls Page 2