Golden Lighting 6005-10 RBZ User Manual

Mounting Strap w/

Part Needed

Quantity

Reason why

( missing, scratched, broken glass, bent, bad finish)

Comments

PARTS & ASSEMBLY SHEET

Read and review installation instruction sheet before

For Customer Service, contact the place of purchase to arrange for replacement parts.

missing or damaged, please note onthis sheet and contact the place of purchase to arrange for replacement

Company Name:_______________________Co. Account #:_____________

to be filled out by retailer

M

F

Fixture Name: Lancaster 6005-10 PW/RBZ

This fixture assembled PO:__________ Date: ________

Notice:

parts.

Please review the parts listing and check for all parts before assembling the fixture. If any parts are

PARTS LIST

Canopy Wire connectors Canopy loop

1ea 10"x 4.5" 2ea P3 Orange 2ea @3/8 x 29mm

Chain

2ea 6ft x3.8mm 2ea 8/32" x 1" 3ea @55 x 1mm

Chain connector Deco nut Nipple

2ea @4X55mm 1ea @15 x 12mm 1ea @3/8 x 45mm

ground screw

1ea 3/4"X4" 2ea @3/8 x 3mm 1ea @15 x 3mm

Part Needed Quantity

Junction Box
Screw

Hex Nut Srping Washer

Socket Washer

F

IXTURE ASSEMBLY INSTRUCTIONS

assembling the fixture.

Fig. 1

6005-10

H

ASSEMBLING THE FIXTURE (Fig. 1)

1. By measuring determine correct number of links needed
for proper hanging height. Use a pair of pliers to open one
link of the Chain (I) then remove the excess chain (I) and
discard it.

NOTE: INSTALL THE GLASS ASSEMBLY AFTER THE
FIXTURE IS HUNG.

6005-10 Parts Installation-100916m.xls

G

I

H
J

K

L

PARTS & ASSEMBLY SHEET

Fixture Name: Lancaster 6005-10 PW/RBZ

2. Use Chain connector (H) to attach the Chain (I) to top

curve of fixture Frame (J) and close the connector as shown.

3. Attach a Chain connector (K) to the top end of the Chain

(J). Repeat steps 1 thru 3 for the second chain.

4. Lace the fixture’s wire through the chain links (I) (every

three links) and pull until taut.

(the wires will run through just one side.)

5. Use Chain connector (H) to attach the top of Chain (I) to
the Canopy loop (A2) and close the chain connector as
shown.

6. Tread the fixtrue wires through the center hole in Canopy
loop.

7. Make sure the weight of the chandelier will be supported
by the chain-not the electrical wire.

Fig 2

F
H

G

I

H
J

K

* You may now install the fixture.

Note: Complete these remaining steps after the fixture is

hung.

8. Place the Glass Shades (M) over the Threaded Sockets

(L), secure the Glass Shades (M) by threading by the Socket

Rings (O) over the socket washers (N) until tight.

9. Install the light bulbs in accordance with the fixture's

specifications.

(DO NOT EXCEED MAXIMUM WATTAGE RATING)

For Customer Service, contact the place of purchase to arrange for replacement parts.

Fig 3

L

M

N
O

6005-10 Parts Installation-100916m.xls