Golden Lighting 4002-1W RSB User Manual

INSTALLATION INSTRUCTIONS

Fixture Name: Loretto 4002-1W RSB

For Wall Mount Light Fixture

WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.

HANGING THE FIXTURE(Fig.1)

1.Carefully remove the new fixture from the carton
and the yellow parts bag. Check that all parts are
included as shown in the illustration and parts list.

2. Shut off power at the circuit breaker and remove
the old fixture from wall, including the old mounting
strap.

3.The Mounting Strap(A) contains several pairs of
threaded holes, find the pair of holes that match
the holes spacing in your fixture Back Plate(D) and
thread the two Fixture Mounting Screws(C) half
way into the Fixture Mounting Strap(A).

4. Place the Mounting Strap(A)over the Junction
Box so the Fixture Mounting Screws(C) are vertical
or horizontal, as required by the fixture type.

5. Attach the Fixture Mounting Strap(B) to the
Junction Box using the two mounting screws(B).
Tighten the screws(B) securely with screwdriver.

CONNECTING THE WIRES (Fig 2)

6. Attach the power supply wires to the fixture
lead wires by connecting BLACK to BLACK (or
SMOOTH) and WHITE to WHITE (or RIBBED).

7. Attach the GROUND wire(GREEN or COPPER)
from the Junction Box and the fixture Ground wire
to the green Ground Screw on the Mounting
Bracket (B) or connect both wires together using
the correct size of wire connectors.
NOTE:Twist the wires together in the same
direction you twist the wire connector onto the
wires.

8. Tuck these wire connections neatly into the
Junction Box.

Fig. 1

Fig. 2

FINISHING THE INSTALLATION(Fig.3)

9. After tucking these wire connections neatly into
the Junction Box and place the fixture Back
Plate(D) over the two Mounting Screws(C) and
secure the Back Plate(D)against the wall by
threading two Deco Nuts(E) over the two Mounting
Screws(C) until tight as shown on Fig.3.

10. Install glass as per the fixture assembly
instructions.
YOUR INSTALLATION IS NOW COMPLETE.
RETURN POWER TO THE JUNCTION BOX AND
TEST THE FIXTURE.

Fig. 3

For Customer Service, contact the place of purchase to arrange for replacement parts.

PARTS & ASSEMBLY SHEET

_

Fixture Name: Loretto 4002-1W RSB

This fixture assembled PO:__________ Date: ________

Notice: Please review the parts listing and check for all parts before assembling the fixture. If any

parts are missing or damaged, please note onthis sheet and contact the place of purchase to arrange
for replacement parts.

Company Name:_______________________Co. Account #:_________

PARTS LIST

below to be filled out by retailer

Mounting Strap 1ea

Hex nut 2ea

Part Needed Quantity
Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments

Mounting
Screws

Wire
connectors

4ea Deco Nut 1ea

3ea Green Screw 1ea

FIXTURE ASSEMBLY INSTRUCTIONS

Read and review installation instruction sheet
before assembling the fixture.

Fig. 4

1. Place the Glass Shade (F) over the Threaded Socket
(G)

2. Holding the Glass Shade ( F ), and secure it by
threading the Socket Ring ( H ) onto the Threaded
Socket ( G ) until tight .

3. Install the light bulbs in accordance with the
fixture's specification .

4002-1W RSB

(DO NOT EXCEED THE MAXIMUM WATTAGE RATING!)

NOTE: INSTALL THE GLASS ASSEMBLY

AFTER THE FIXTURE IS HUNG.

For Customer Service, contact the place of purchase to arrange for replacement parts.