Golden Lighting 3711-ND3 CB User Manual

PARTS & ASSEMBLY SHEET

Fixture Name

: Rockefeller 2488-ND3 FI & 3711-ND3 CB

This fixture assembled PO:__________ Date: ________

Notice:

damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts.

PARTS LIST

Canopy Mounting Screws Top loop

1ea ∅6-1/2"*H1-1/2" 2ea 8#32-IP*1" 1ea 1/8-IP*H60mm

Chain Wire connectors Nipple

1ea 6ft ∅3.8 3ea P3 Orange 1ea 1/4-IP*H60mm

Chain connector

2ea ∅5.8*H61mm 1ea ∅1-1/8"*H42mm 1ea W4-1/8"*E1"*H5mm

Finial

Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or

Company Name:_______________________Co. Account #:_____________

to be filled out by retailer

Canopy loop
with Collar

Mounting strap

1ea 1/8-27-IP*H32mm

Part Needed Quantity

Part Needed Quantity
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments

F

IXTURE ASSEMBLY INSTRUCTIONS

Read and review installation instruction sheet before
assembling the fixture.

ASSEMBLING THE FIXTURE (Fig.1)

1. Gently spread the arms until evenly spaced if arms are
packed closed

2. Align the arms over the arm connector screws (V) at top
of fixture center column and secure in place with the Deco
nuts (T) that were attached there.

3. Feed the fixture wires through the Top loop (J) and pull
the wires until taut.

Fig 1

2488-ND3 FI & 3711-ND3 CB

4. Then screw the Top Loop (J) to the threaded center
column of Frame (M) until tight.

NOTE: I

NSTALL THE GLASS ASSEMBLY AFTER

THE FIXTURE IS HUNG.

For Customer Service, contact the place of purchase to arrange for replacement parts.

24883711-PartsInstallation_20110105m.xls

10. Make sure the weight of the chandelier will be supported

PARTS & ASSEMBLY SHEET

Fixture Name: Rockefeller 2488-ND3 FI & 3711-ND3 CB

5. By measuring determine correct number of links needed

for proper hanging height. Use a pair of pliers to open one

link of the Chain (C2) then remove the excess Chain (C2)

and discard it.

6. Use one chain connector (E2) to attach one end of the

chain to the Top loop (J) and close the chain connector.

7. Feed the fixture wires through the Chain (every three

links) and pull the wires until taut.

8. Slip Canopy loop collar (B2) over the chain, then do the

same with the canopy (F2).

Fig 2ASSEMBLING THE FIXTURE (Fig.2)

9. When ready to complete the installation Use the other

chain connector and attach the other end of the chain to the

canopy loop (A2) and close the chain connector.

by the chain-not the electrical wire.

* You may now install the fixture.

Note: Complete these remaining steps after the fixture is

hung.

11. Place the Glass Shades (O) over the Threaded sockets

(P),

secure the Glass Shades (O) by threading by the

Socket Rings (N) until tight.

12. Thread the Finial (S) onto the stem (M).

Fig 3

13. Install the light bulbs in accordance with the fixture's

specifications.

(DO NOT EXCEED MAXIMUM WATTAGE RATING)

For Customer Service, contact the place of purchase to arrange for replacement parts.

24883711-PartsInstallation_20110105m.xls