Golden Lighting 3500-M1L AB User Manual

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

Read and review installation instruction sheet
before assembling the fixtur e.

ASSEMBLING THE FIXTURE (Fig. 1)

Fig. 1

This fixture assembled PO:__________ Date: _ ____ ___

PARTS & ASSEMBLY SHEET

Notice:

Company Name:_______________________ Co. Account #:___________

to be filled out by retailer

Fixture Name: Waverly 3500-M1L AB

Please review the parts listing and check for all parts before assembling the fixture. If any parts are

missing or damaged, please note on this sheet and contact the place of purchase to arrange for replacement
parts.

PARTS LIST

Canopy Wire Connectors Hex Nut

1ea D6"X1" 3ea P4 Orange

Chain

1ea 6ft x3.8mm 2ea 8/32" x 1" 1ea @15 x 2mm

Chain
Connector

2ea @4.2X50mm 1ea @3/8 x 40mm x 5mm 1ea @3/8 x 50mm

Mounting Strap

w/ ground screw
1ea 3/4"X4"

Part Needed Quantity

Junction Box
Screw

Canopy Loop
with Collar

2ea @3/8 x 3mm

Spring Washer

Nipple

FIXTURE ASSEMBLY INSTRUCTIONS

3500-M1L AB

1.Place the socket onto Stem (P) after sliding on Shade
(Q).

2. Thread the Top Loop (J) onto Stem (P). Hand-tighten
until snug.

For Customer Service, contact the place of purchase to arrange for replacement parts.

For Customer Service, contact the place of purchase to arrange for replacement parts.

Fig. 2

PARTS & ASSEMBLY SHEET

Fixture Name: Waverly 3500-M1L AB

ASSEMBLING THE FIXTURE (Fig. 2)

3. Slide on the socket and secure it by threading
Socket Ring ( R) onto the threaded socket unt il
tight.

4. Measure to determine the correct number of
links needed for the prope r ha nging he ight . U se a
pair of pliers to open one link of the Chain (K) then
remove and discard the excess chain.

5. Use Chain Connector ( L) to attach one end of
the chain to the Top Loop (J) and close the c ha in
connector.

6. Feed the fixture wires through the Chain (every
three links) and pu ll t he wires u nt il tau t .

7. Slip Canopy Loop Collar (H) over the chain. Then

7. Slip Canopy loop collar (H) over the chain, then do the

do the same with the Canopy ( G).

same with the canopy (G).

8. To complete the installation, use the other chain

8. When ready to complete the installation Use the other

connector to attach the ot he r end of the chain to

chain connector and attach the other end of the chain to
the canopy loop (F) and close the chain connector.

Canopy Loop (F) and close the chain connector.

9. Make sure the weight of the chandelier will be

9. Make sure that the weight of the chandelier will

supported by the chain-not the electrical wire.

be supported b y the chain, not the electrical wire.

* You may now install t he fixture.

* You may now install the fixture.
Note: Complete these remaining steps after the

fixture is hung.

10. Install the light bulb (not provided) in
accordance with the fixture's specifications.

(DO NOT EXCEED MAXIMUM WATTAGE RATING)