Golden Lighting 3071-6 GG User Manual
2ea @1/2 x 4mm
Part Needed Quantity
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
PARTS LIST
Company Name:_______________________Co. Account #:_____________
to be filled out b y retailer
PARTS & ASSEMBLY SHEET
This fixture assembled PO:__________ Date: ________
Fig. 1
For Customer Service, contact the place of purchase to arrange for replacement parts.
Read and review installation instruction sheet before
assembling the fixture.
J
M
Fixture Name: Athena 3071-3P GG
Notice: Please review the parts listing and check f or all parts before assembling the fixture. If any parts are missing or
damaged, please note on this sheet and co ntact the place of purchase to arrange for replacement parts.
Canopy Wire Connectors Top Loop
1ea 5-5/8"W× 2-5/8"H 3ea A4 Orange 1ea D50mm×H60mm
Chain
1ea 6ft x3.8mm 2ea 8/32" x 1" 1ea @15 x 2mm
Chain
Connector
2ea @4.X50mm 1ea @3/8 x 40mm x 5mm 1ea @1/2 x 75mm
Mounting Strap
w/ ground screw
1ea 3/4"X4"
Part Needed Quantity
F
IXTURE ASSEMBLY INSTRUCTIONS
Junction Box
Screw
Canopy Loop
with Collar
Hex Nut
Spring Washer
Nipple
3071-3P GG
Note: The Canopy, Chain, and Twisted Candles
are preassembled onto the fixture body.
1. Place Top Loop (J) over the threaded nipple
of Top Cap (M) and twist until snug.
PARTS & ASSEMBLY SHEET
Fig. 2
For Customer Service, contact the place of purchase to arrange for replacement parts.
J
M
H
F
E
D
A
C
B
L
K
G
L
Fixture Name: Athena 3071-3P GG
ASSEMBLING THE FIXTURE (Fig. 2)
2. Measure to determine the correct number of links
needed for proper hanging height. Use a pair of
pliers to open one link of Chain (K). Remove and
discard excess Chain (K).
3. Use one Chain Connector (L) to attach one end
of the chain toTop Loop (J) then close the chain
connector.
4. Feed the fixture wires through the chain (every
three links) and pull the wires until taut.
5. Slip Canopy Loop Collar (H) over the chain, then
do the same with Canopy (G).
6. When ready to complete the installation, use the
remaining chain connector to attach the other end
of the chain to Canopy Loop (F). Then close the
chain connector.
7. Make sure the weight of the chandelier will be
supported by the chain-not the electrical wire.
* You may now install the fixture.
Note: Complete these remaining steps after the
fixture is hung.
Loading...