Golden Lighting 2049-4P FB User Manual

Page 1
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
Read and review installation instruction sheet before
Fig. 1
PARTS & ASSEMBLY SHEET
Company Name:_______________________Co. Account #:_____________
below to be filled out by retailer
Fixture Name: Valencia 2049-2W FB
This fixture assembled PO:__________ Date: ________
Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing
or damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts.
PARTS LIST
1 ea 3/4"*1" Wire Connnector
Junction Box Screw (B)
2 ea #8-32N*H32mm Hex Nut
Nipple (C)
1ea 3/8"*H45mm Deco Nut (Round) (I)
3 ea P3
Green Ground Screw
1 ea #8-32N*H10mm
Part Needed Quantity Part Needed Quantity
2 ea 5/32"*H3.5mm Crystal (J)
2 ea W21*75Lmm
1 ea 5/32"xH12mm Candle Sleeve (H)
2 ea W32xH95mm

FIXTURE ASSEMBLY INSTRUCTIONS

assembling the fixture.
1. Slide the candle sleeve (H) over Socket
2049-2W FB
2. Attach the Crystals (J).
3.Install light bulb to Socket in accordance with the
fixture's specifications.
(DO NOT EXCEED THE MAXIMUM WATTAGE RATING!)
For Customer Service, contact the place of purchase to arrange for replacement parts.
Page 2
INSTALLATION INSTRUCTIONS
included as shown in the illustration and parts list.
HOUSE WIRES
WHITE
BLACK
RIBBED (WHITE)
SMOOTH (BLACK)
FIXTURE WIRES
C
E
B
A
JUNCTION BOX (CEILING)
Fixture Name: Valencia 2049-2W FB
For Wall Mount Light Fixture
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
HANGING THE FIXTURE (Fig. 1)
1. Carefully remove the new fixture from the carton and the yellow bag that holes all your parts. Check that all parts are
2. Shut off power at the circuit breaker and remove the old fixture from wall, including the old mounting strap.
3. Thread other end of the Nipple (C) with Canopy Loop attached into Mounting Strap (D).
4. Take this mounting strap assembly and mount to ceiling junction box with Mounting screws (E). Tighten screw securely with screw driver.
CONNECTING THE WIRES (Fig. 2)
5. Attach the power supply wires to the fixture lead wires by connecting BLACK to BLACK (or SMOOTH) and WHITE to WHITE (or RIBBED).
6. Ground wire connection: Connect fixture ground wire to supply ground wire (usually with green insulation) with wire connector. If there is no supply ground wire at ceiling juction box then attach fixture ground wire securely onto green grounding screw located at mounting bar.
Fig. 1
Fig. 2
NOTE: Twist the wires together in the same direction you twist the wire connector onto the wires.
7. Tuck these wire connections neatly into the Junction Box.
FINISHING THE INSTALLATION (Fig. 3)
8. Place the fixture Back Plate (K) over the Nipple (C), so it protrudes through the hole in the Back Plate (K)
9. Thread the Deco Nut (I) onto the Nipple (C) and continue turning until the Back Plate (K) is snug against the wall.
10. Install light bulbs in accordance with the fixture's specifications.
YOUR INSTALLATION IS NOW COMPLETE. RETURN POWER TO THE JUNCTION BOX AND TEST THE FIXTURE.
For Customer Service, contact the place of purchase to arrange for replacement parts.
Fig. 3
Loading...