Golden Lighting 1993-WSC PS User Manual

Reason why (missing, scratched, broken glass, bent, bad finish)
Comments
Read and review installation instruction sheet before
Notice:
Company Name:_______________________Co. Account #:_____________
below to be filled out by retailer
PARTS & ASSEMBLY SHEET
Fixture Name: Joia 1993-WSC PS
This fixture assembled PO:__________ Date: ________
Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or
damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts.
PARTS LIST
Mounting strap
1ea 4" 1ea 3/8 X 35mm 2ea 8/32 X 1"
Spring washer Hex nut Deco nut (round nut)
1ea 15 X 3mm 1ea 3/8 X 3mm 1ea 16mm
Green Ground screw
1ea 8/32" X 10mm 3ea P4 Orange
Part Needed Quantity Part Needed Quantity
Threaded rod
(Nipple)
Wire connnector
Mounting screw
FIXTURE ASSEMBLY INSTRUCTIONS
assembling the fixture.
Fig. 1

1993-W S C PS

J
1. Install the light bulbs i n ac c ordance with the fixture's specif ic ations.
(DO NOT EXCEED THE MAXIMUM WATTAGE RATING!)
H
For Customer Service, contact t he place of purchase to arrange for replacement parts.
Bulb
(Not Provided)
INSTALLATION INSTRUCTIONS
HOUSE WIRES
WHITE
BLACK
WHITE
BLACK
FIXTURE WIRES
WIRE CONNECTOR
Fixture Name: Joia 1993-WSC PS
For Wall Mount Light Fixture
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
HANGING THE FIXTURE (Fig. 1)
1. Carefully remove the new fixture from the carton and the yellow bag that holds all your parts. Check that all parts are included as shown in the illustration and parts list.
2. Shut off power at the circuit breaker and remove the old fixture from wall, including the old mounting strap.
3. Take Threaded Rod (D) from parts bag and thread into center screw hole on Mounting Strap (A). Tighten with Hex Nut (B) and Spring Washer (C).
4. Attach the Mounting Strap (A) to the Junction Box (I) using the two Mounting Screws (E). Tighten the screws securely.
CONNECTING THE WIRES (Fig. 2)
5. Attach the power supply wires to the fixture lead wires by connecting BLACK to BLACK (or SMOOTH) and WHITE to WHITE (or RIBBED).
NOTE: Twist the wires together in the same direction you twist the wire connector onto the w ires .
6. Attach the GROUND wire (GREEN or COPPER) from the junction box and the fixture ground wire to the green ground screw on the Mounting Bracket (A). Or connect both w ires together using a wire connector.
7. Tuck these wire
FINISHING THE INSTALLATION (Fig. 3)
8. Place the fixture Back Plate (J) over the Threaded Rod ( D), so it protrudes through the hole in the Back Plate (J).
9. Thread the Deco Nut (H) onto the Threaded Rod (D) and continue turning until the Back Plate (J) is snug against the wall.
10. Install bulbs according to the fixture specifications. YOUR INSTALLATION IS NOW COMPLETE.
RETURN POWER TO THE JUNCTIO N BOX AND TEST THE FIXTURE.
connections neatly into the Junction Box.
Fig. 1
Fig. 2
Fig. 3
J
H
D
Bulb (Not Provided)
For Customer Service, contact the place of purchase to arrange for replacement parts.
Loading...