Golden Lighting 1993-8 PS User Manual
Part Needed Quantity
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
For Customer Service, contact the place of purchase to arrange for replacement parts.
Read and review installation instruction sheet
before assembling the fixture.
Fig. 1
PARTS & ASSEMBLY SHEET
Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or
Company Name:_______________________Co. Account #:_____________
to be filled out by retailer
Fixture Name: Joia 1993-8 PS
This fixture assembled PO:__________ Date: ________
Notice:
damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts.
PARTS LIST
Canopy
1ea D150*H34mm 3ea A4 Orange 1ea
Chain
1ea 6ft x 4.2mm 2ea 8/32" x 1" 1ea @15 x 2mm
Chain
Connector
2ea @4.2X50mm 1ea @3/8 x 40mm x 5mm 1ea @3/8 x 455mm
Mounting Strap
w/ ground screw
1ea 3/4"X4" 2ea @3/8 x 3mm
Part Needed Quantity
IXTURE ASSEMBLY INSTRUCTIONS
F
Wire
Connectors
Junction Box
Screw
Canopy Loop
with Collar
Hex Nut
Top Loop
Spring Washer
Nipple
1993-8 PS
Note: The wire cage and fabric shade are
already assembled on the fixture body
1. Thread the nipple (N) into the coupling of
fixture body (O).
2. Place the top cap (M) over the nipple (N)
and secure it by threading the Top loop (J) on
until snug.
PARTS & ASSEMBLY SHEET
C
D
Fixture Name: Joia 1993-8 PS
ASSEMBLING THE FIXTURE (Fig. 2)
3. By measuring determine correct number of
links needed for proper hanging height. Use a
pair of pliers to open one link of the Chain (K)
then remove the excess Chain (K) and discard
it.
4. Use one chain connector (L) to attach one
end of the chain to the Top loop (J) and close
the chain connector.
5. Feed the fixture wires through the Chain
(every three links) and pull the wires until taut.
6. Slip Canopy loop collar (H) over the chain,
then do the same with the canopy (G).
7. Slip Canopy loop collar (H) over the chain, then do the
same with the canopy (G).
7. When ready to complete the installation Use
the other chain connector and attach the other
8. When ready to complete the installation Use the other
end of the chain to the canopy loop (F) and
chain connector and attach the other end of the chain to
close the chain connector.
the canopy loop (F) and close the chain connector.
8. Make sure the weight of the chandelier will
9. Make sure the weight of the chandelier will be
be supported by the chain-not the electrical
supported by the chain-not the electrical wire.
wire.
* You may now install the fixture.
* You may now install the fixture.
Note: Complete these remaining steps after
the fixture is hung.
9. Install the light bulbs (not provided) in
accordance with the fixture's specifications.
(DO NOT EXCEED MAXIMUM WATTAGE RATING)
Fig. 2
For Customer Service, contact the place of purchase to arrange for replacement parts.
Loading...