Golden Lighting 1993-5 PS User Manual

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

For Customer Service, contact the place of purchase to arrange for replacement parts.

Read and review installation instruction sheet before

PARTS & ASSEMBLY SHEET

Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or

Company Name:_______________________Co. Account #:_____________

to be filled out by retailer

Fixture Name: Joia 1993-5 PS

This fixture assembled PO:__________ Date: ________

Notice:

damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts.

PARTS LIST

Canopy Wire Connectors Top Loop

1ea D150*H34mm 3e a A4 Orange 1ea

Chain

1ea 6ft x3.8mm 2ea 8/32" x 1" 1ea @15 x 2mm

Chain Connector Nipple

2ea @4.2X50mm 1ea @3/8 x 40mm x 5mm 1ea @3/8 x 455mm

Mounting Strap

w/ ground screw
1ea 3/4"X4" 2ea @3/8 x 3mm

Part Needed Quantity

Junction Box
Screw

Canopy Loop
with Collar

Hex Nut

Spring Washer

FIXTURE ASSEMBLY INSTRUCTIONS

assembling the fixture.

Fig. 1

1993-5 PS

Note: The wire cage and fabric shade are
already assembled on the fixture body

1. Thread the nipple (N) into the coupling of
fixture body (O).

2. Place the top cap (M) over the nipple (N)
and secure it by threading the Top loop (J) on
until snug..

PARTS & ASSEMBLY SHEET

C

D

Fixture Name: Joia 1993-5 PS

ASSEMBLING THE FIXTURE (Fig. 2)

3. By measuring determine correct number of
links needed for proper hanging height. Use a
pair of pliers to open one link of the Chain (K)
then remove the excess Chain (K) and discard it.

4. Use one chain connector (L) to attach one end
of the chain to the Top loop (J) and close the
chain connector.

5. Feed the fixture wires through the Chain (every
three links) and pull the wires until taut.

6. Slip Canopy loop collar (H) over the chain,
then do the same with the canopy (G).

7. Slip Canopy loop collar (H) over the chain, then do the

7. When ready to complete the installation Use

same with the canopy (G).

the other chain connector and attach the other
end of the chain to the canopy loop (F) and close

8. When ready to complete the installation Use the other

the chain connector.

chain connector and attach the other end of the chain to
the canopy loop (F) and close the chain connector.

8. Make sure the weight of the chandelier will be
supported by the chain-not the electrical wire.

9. Make sure the weight of the chandelier will be supported
by the chain-not the electrical wire.

* You may now install the fixture.
Note: Complete these remaining steps after the

* You may now install the fixture.

fixture is hung.

9. Install the light bulbs (not provided) in
accordance with the fixture's specifications.

(DO NOT EXCEED MAXIMUM WATTAGE RATING)

Fig. 2

For Customer Service, contact the place of purchase to arrange for replacement parts.