Golden Lighting 1051-BA1 SBZ User Manual

Socket Ring (J) to Socket (F) until tight.

fixture's specifications.

PARTS & ASSEMBLY SHEET

Fixture Name: Hidalgo 1051-BA1 SBZ

This fixture assembled PO:__________ Date: ________

Notice:

are missing or damaged, please note onthis sheet and contact the place of purchase to arrange for
replacement parts.

PARTS LIST

Circular
Mounting strap

Green Ground
Screw

Part Needed Quantity

Part Needed Quantity
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments

Please review the parts listing and check for all parts before assembling the fixture. If any parts

Company Name:_______________________Co. Account #:_____________
to be filled out by retailer

1ea

1ea

Box Screw
Mounting
screws

Wire
Connnector

2sets

3ea

Deco Nut
(round nut)

2ea

F

IXTURE ASSEMBLY INSTRUCTIONS

Read and review installation instruction sheet
before assembling the fixture.

1.Slide the Glass Shade ( H ) over Socket (F)
and secure Glass Shade (H) by threading the

2. Install the light bulbs in accordance with the

(DO NOT EXCEED THE MAXIMUM WATTAGE RATING)

NOTE: I

NSTALL THE GLASS ASSEMBLY

AFTER THE FIXTURE IS HUNG.

1051-BA1 SBZ

Fig 1

For Customer Service, contact the place of purchase to arrange for replacement parts.

INSTALLATION INSTRUCTIONS

)

WHITE (or RIBBED).

together using the correct size of wire connectors.

the wire connector onto the wires.

FINISHING THE INSTALLATION (Fig.3)

against the wall.

Fixture Name: Hidalgo 1051-BA1 SBZ

For Wall Mount Light Fixture

WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.

HANGING THE FIXTURE (Fig.1

1. Carefully remove the new fixture from the carton and the

yellow bag that holds all your parts. Check that all parts are

included as shown in the illustration and parts list.

2. Shut off power at the circuit breaker and remove the old

fixture from ceiling, including the old mounting strap.

3. The Circular Mounting Strap (B) contains several pairs of

threaded holes, find the pair of holes that match the hole

spacing in your fixture Back Plate (G) and thread the two

Mounting Screws (C) half way into the Mounting Strap (B) facing

down,Secure in place with hex nuts. These will have their

threaded ends protrude through the two holes in the Back Plate

(G).

4. Place the Mounting Strap (B) over the junction box.

5. Attach the Mounting Strap (B) to the Junction Box using the

two mounting screws (A). Tighten the screws (A) securely with

screw driver.

CONNECTING THE WIRES (Fig 2)

6. Attach the power supply wires to the fixture lead wires by

connecting BLACK to BLACK (or SMOOTH) and WHITE to

Fig. 1

Fig. 2

7. Attach the GROUND wire(GREEN or COPPER) from the

Junction Box and the fixture Ground wire to the green Ground

Screw on the Mounting Plate (B) or connect both wires

NOTE: Twist the wires together in the same direction you twist

8. Tuck these wire connections neatly into the Junction Box.

9. After tucking these wire connections neatly into the Junction

Box and place the fixture Front Plate (G) over the two Mounting

Screws (C) and secure against the Mounting Plate by threading

two Deco Nuts (I) over the two Mounting Screws (C) until snug

10. Install the light bulbs and glass shade as per the fixture

assembly sheet.

YOUR INSTALLATION IS NOW COMPLETE. RETURN

POWER TO THE JUNCTION BOX AND TEST THE FIXTURE.

For Customer Service, contact the place of purchase to arrange for replacement parts.

Fig. 3