Golden Lighting 1051-5 SBZ User Manual
F
and pull the wires until taut.
PARTS & ASSEMBLY SHEET
Fixture Name: Hidalgo 1051-5 SBZ
This fixture assembled PO:__________ Date: ________
Notice:
missing or damaged, please note onthis sheet and contact the place of purchase to arrange for
replacement parts.
PARTS LIST
Canopy
Chain 6ft
Green screws 1ea
Mounting Strap 1ea Hex Nut 1ea
Part Needed Quantity
Part Needed Quantity
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
Please review the parts listing and check for all parts before assembling the fixture. If any parts are
Company Name:_______________________Co. Account #:_____________
to be filled out by retailer
Mounting
Screws
1ea
Canopy loop
and Canopy
loop collar
Chain
connector
2ea Top loop 1ea
1set Wire connectors 3ea
2ea Nipple 1ea
IXTURE ASSEMBLY INSTRUCTIONS
Read and review installation instruction sheet before
assembling the fixture.
1. This fixture is packed with the arms closed.
Gently spread the arms (C) until evenly spaced.
2. Feed the fixture wires through the Top loop (A)
3.Then screw the Top Loop (A) to the top of Frame
coupler (B) until tight.
NOTE: I
NSTALL THE GLASS ASSEMBLY
AFTER THE FIXTURE IS HUNG.
For Customer Service, contact the place of purchase to arrange for replacement parts.
1051-5 SBZ
Fig 1
For Customer Service, contact the place of purchase to arrange for replacement parts.
6. Use one chain connector(E2) to attach one end of
supported by the chain-not the electrical wire.
clip(J) ,secure with Ball nut(I). (see Fig2)
PARTS & ASSEMBLY SHEET
Fixture Name: Hidalgo 1051-5 SBZ
(E) by threading by the Socket Ring (D) until tight.
fixture's specifications.
A2
E2
D2
4. Slide Center Ring (H) up to the Arms (C) and
make the screw(G) through the hole of the Steel
Fig 2
5. By measuring determine correct number of links
needed for proper hanging height. Use a pair of
pliers to open one link of the Chain (C2) then
remove the excess Chain (C2) and discard it.
the chain to the Top loop (D2) and close the chain
connector.
7. Feed the fixture wires through the Chain (every
three links) and pull the wires until taut.
8. Slip Canopy loop collar (B2) over the chain, then
do the same with the canopy (F2).
9. When ready to complete the installation Use the
other chain connector and attach the other end of
the chain to the canopy loop (A2) and close the
chain connector.
10. Make sure the weight of the chandelier is
Fig 3
B2
E2
C2
* You may now install the fixture.
Note: Complete these remaining steps after the
fixture is hung.
11. Place the Glass Shade (E) over the Threaded
Socket (F),place the Socket ring (D) over the
threaded socket (F) then secure the Glass Shade
12. Install the light bulbs in accordance with the
(DO NOT EXCEED THE MAXIMUM WATTAGE RATING)
Fig 4
Loading...