goldenHood RE – 6143W, RE-6143S, RE-9137W, RE8137, RE7137 Installation & Operation Instructions

1

RE – 6143W

Installation & Operation Instructions for Australia & New Zealand

goldenHOOD® Rangehoods

Style RE-137 === Model RE9137, RE8137, RE7137
Style RE-139 === Model RE9139, RE7139, RE6139
Style RE-142 === Model RE9142, RE7142, RE6142
Style RE-143 === Model RE9143, RE7143, RE6143
Style RE-242 === Model RE9242

Warning! Read this instruction before installation and operation.

Under certain circumstances domestic appliances may be dangerous.

• The minimum distance between the cooker hob surface and the lowest part of the range hood is 650mm,
and the maximum is 750mm, or follow your local building code and the AGA specifications.

• Exhaust air should not be discharged into any chimney or flue, which may carry combustible products from
other sources. In addition, exhaust air should not be discharged into the wall cavity or into the roof space
unless designed for the purpose. All other regulations concerning the discharge of exhaust air have to be
fulfilled.

• There shall be adequate ventilation of the room when the range hood is used at the same time as
appliances burning gas or other fuels. Do not flambé under the range hood.

• You must read the details concerning the method and frequency of cleaning. There is a fire risk if cleaning
is not carried out in accordance with the instructions.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.

• Young children or infirm persons without supervision do not intend to use this appliance.

• Young children should be supervised to ensure that they do not play with the appliance.

• If the supply cord is damaged, it must be only replaced by an authorized or qualified person.

• Accessible parts may become hot when used with cooking appliances.

• Any repairing works of this appliance can only be carried out by an authorized or qualified person.

• Disconnect the electricity before repair, replace or cleaning to this appliance.

• Do not touch the lamps or lamps covers after the appliance just has been used.

• Do not remove filters with the range hood in operation.

• This appliance is designed for domestic use only, do not use for commercial or industrial purpose.

The manufacturers refuse to accept any responsibility for eventual damages, because of failure to
observe the instructions.

Installation

Built-in installation.

Note: Remove the wall mounting brackets on the hood before installation.
To be installed under an over-head cabinet. Cut a ∅170-180mm hole on the bottom panel of cabinet according to
the position of air vent on the hood. And cut another ∅40mm hole for power plug to go through. If you have a built-in
space, pre-drill 2 ∅4mm holes on each side panel of the hood, then fasten the screws from inside the hood to the
cabinet. Alternatively, pre-drill a ∅4mm hole at each top corner of the hood, then fasten the hood to the bottom
panel of the cabinet. A car jack with a piece of timber board is an idea to hold the hood while fastening. Make sure
the front of the hood is slightly tilted up to allow the cooking grease to flow into the grease collectors, which at the
back of the hood. And then install the ducting flue.

Warning: Failure to install the screws or fixing device in accordance with these instructions may result in electrical
hazards, and it may cause personal injured.

Electrical connection

The hood is fitted with molded power cord and plug. A 10amp power point is required for plug-in connection.

2

Typical installation drawing

Note: This drawing for general guidance only,
may not suit some installing application.

Model RE-6143W dimension

0 0

Ø150mm top vent

0

Rangehood

0

650~750mm

0 0 0 0

Cooker

Exhaust flue ducting

• Plan and check the ducting route before starting. Duct size must not smaller then the hood’s exhaust outlet.

• Keep the length of duct as short as possible, and also keep the number of bends to a minimum.

• Rigid duct is better then flexible one, if flexible duct to be used, use aluminum flexible duct.

• Use roof silicone, ducting tape or cable ties for joining and securing.

• Pay attention to waterproofing on roof flashing. A qualified person is recommended for roof duct installation.

Note: goldenHOOD stocks wide range of ducting materials for rangehoods ducting application, for detail information
and pricing call 03 9894 1820 or Local Call 1300 1313 09.

Operation

Turn on the hood 1 minute before cooking to create an air movement in the kitchen. Do not open too many windows
around kitchen especially if windy outside, because the entered-wind will spreads the grease around. After cooking,
let the fans stay on rotation for 2 minutes to draw out the remaining cooking odors.

Cleaning & Maintenance-

Self-cleaning

This hood is a filter-free, self-clean unit. Cleaning frequency depends on the cooking styles, generally once a week.
Add detergent with warm water (50~60oC) in a sprayer and fine-spray the mixture on the rotating blades. The high­speed motion will wash away the grease and deposit them in the grease collectors. Empty the collectors regularly.
The best time for spray-clean is just after cooking as the grease colleted in the hood still warm and fresh, it is easy
to clean and wash out at this time. Spray 20 to 30 puffs every day for maximum cleanness.

Clean the internal parts

Depending on the frequency of self-cleaning and the cooking styles, this type of cleaning may need to carry out
once a year. Turn off power supply first, unscrew the bottom panel of the hood, take down the grease collecting
disc, remove the plastic gray cover, unscrew the blade-lock screw, take down the blade set and wash all parts with
warm soapy water, rinse and dry them, then refit to their places.

General maintenance

• Particular care must be taken with sharp edges on the rangehood.

• In high humidity and coastal environments, cleaning should be carried out frequently.

• Ensure the rangehood is switched off before cleaning.

• Wipe the rangehood surfaces with mild detergent or soapy water using a sponge or soft cloth. Do not use

oven cleaners, caustic solutions or abrasive materials.

Specifications and technical data

Model RE-6143W Colour White Type of fan Centrifugal
Voltage 240 a.c. 50Hz Air vent Ø 150mm top venting Material of fan Aluminum
Total power 190W Revolutions 1100 ~ 1450 RPM C Tick Mark N12157
Dimension W595xD560xH170mm Speed control 2-Speed rocker switches Approval number Q061171
Airflow 680~880 M3 / Hr Noise level 45 ~ 58 dBA Country of Origin Taiwan

goldenHOOD® Rangehoods

143 Whitehorse Rd, Blackburn VIC 3130. Tel: [phone] Fax: [phone]

[e-mail] www.goldenhood.com

Customer Care Line: 1300 1313 09