Golden Blount Sizzler Jr User Manual

TEXAS SIZZLER “JR”

INFRA-RED GAS GRILL

OWNER’S MANUAL

FOR OUTDOOR USE ONLY

CONTENTS:

▪ Location Requirements. . . . . . . . . . . 1

▪ Assembly . . . . . . . . . . . . . . . . . . . . . . 1

▪ Gas Connection . . . . . . . . . . . . . . . . . 3

▪ Operation . . . . . . . . . . . . . . . . . . . . . . 4

▪ Maintenance and Cleaning . . . . . . . . 6

▪ Replacement Parts. . . . . . . . . . . . . . . 7

▪ Troubleshooting . . . . . . . . . . . . . . . . . 7

▪ Warranty . . . . . . . . . . . . . . . . . . . . . . . 8

FOR YOUR
SAFETY

If you smell gas:

1. Shut off gas to the
appliance.

2. Extinguish any open
flame.

3. Open lid.

4. If odor continues,
immediately call
your gas supplier
or your fire
department.

FOR YOUR
SAFETY

1. Do not store or use
gasoline or other
flammable vapors
or liquids in the
vicinity of this or
any other
appliance.

2. An LP Cylinder not
connected for use
shall not be stored
in the vicinity of
this or any other
appliance.

Golden Blount Inc.

4301 Westgrove Dr., Addison, Texas 75001

[phone]

LOCATION REQUIREMENTS:

WARNING:

This appliance should not be located closer than 10 inches to any adjacent combustible surface or under
any unprotected combustible construction.

WARNING: This appliance is designed for outdoor use only.This appliance must be on a level, stable surface in an

open area.

Do not locate this appliance in a confined space.Heat and smoke will rise from this appliance so covered locations should
be avoided.

Minimum clearances must be maintained when using this appliance.The ventilation louvers must remain clean and free of
debris to avoid reduction of ventilation air.

ASSEMBLY:

P

ortable/Flat Surface Use:

1. Carefully remove grill from car ton and locate (4) bottom feet.

2. Gently position grill on its back so as to expose bottom of grill. (Figure 1.)

3. Attach (4) bottom feet into (4) holes in bottom of grill. (Figure 2.)

4. Re-position grill with (4) feet on flat surface.

NOTE: Bottom feet need to be removed if using optional grill bag.

Continued on next page

Figure 1. Figure 2.

1

Optional Pedestal Base With Shelves:

1. Carefully remove grill from car ton.

2. Remove pedestal base from car ton and locate hardware to attach grill to pedestal.

3. Position pedestal on flat surface and locate (4) holes on each corner of “x” brace on top of pedestal. (Figure 3.)

4. Position grill on top of “x” brace and align holes in grill bottom with holes in “x” brace.

5. Attach (4) bolts with washers in each hole and tighten. (Figure 4.)

6. Pedestal base can be secured to floor using (3) brackets under bottom base cover. (Figure 5.)

Optional marine mount (see separate instructions included with marine mount kit.)

Figure 3. Figure 4.

Figure 5.

2