Gold Digger GC-1061 Owner's Manual

cC

OWNER’S MANUAL MODEL GC-1061

Please read before using this equipment

Metal Detector

FEATURES

With your Metal Detector, you can hunt
for coins, relics, jewelry, gold, and silver
just about anywhere. This metal detector
is very versatile and easy to use.

The detector’s features include:

Earphone Jack –

lets you connect

earphones (not supplied) to the detector
for privacy.

View Meter and Pointer – shows the
probable type of metal being detected .

Waterproof Search Coil – lets you use
the detector’s search coil even if you
must put it under water.

Note: The search coil is waterproof, but
the control housing is not waterproof.

Adjustable stem – lets you adjust the
detector’s length for comfortable use.

Note: Your metal detector requires six
AA alkaline batteries (not supplied)

TREASURE HUNTER’ CODE OF

ETHICS

All treasure hunt ers might be judged by the
example you set. Here are a few basic rules
you should follow while using your detector.

 Always get permission before searching

any site.



Respect the rights and property of

others.

 Observe all national, state, and local

laws while treasure hunting.



Never destroy historical or

archaeological treasures. If you are not
sure about an object you have found,
contact a museum or historical society
in your area.

 Leave the land and vegetation as it was.

Fill in any holes you dig.

 Use your detector only in safe areas.
 Dispose of any junk you find, only in

approved areas. Do not leave it for the
next treasure hunter to find.

2

cC

PREPARATION

de ele Prologo
Muchas gracias por su compra del produ

ADJUSTING THE STEM

Follow these steps to adjust the metal
detector’s stem.

1. Turn the stem’s lock nut clockwise

until it loosens.

2. Lengthen or shor ten the ste m so when

you stand upright with the detector in
your hand, the search coil is level with
and about 1/2 to 2 inches above the
ground with your arm relaxed at your
side.

3. T

urn the stem’s lock nut counter

clockwise to lock it in place.

ADJUSTING THE SEARCH

COIL

Loosen the knobs at the search coil’s end, then
adjust the search coil to the desired angle. (The
search coil should be parallel with the ground.)
Tighten the knobs just enough t o keep the search
coil from rotating or wobbling.

INSTALLING BATTERIES

You need six AA batteries to power your
detector.

Cautions:

 Use only fresh batteries of the required

size and recommended type.

 Do not mix old and new batteries, different

types of batteries (standard, alkaline, or
rechargeable), or rechargeable batteries of
different capacities.

1. If the detector is on, turn VOLUME on the

control housing) to OFF. (The control

clicks.)

2. Press on the battery compartment cover

and slide the cover off in the direction of
the arrow.

3. Insert the batteries into the compartment as

indicated by the polarity symbols (+ and -)
marked inside the compartment.

4. Replace the cover.

Cautions:

 Always remove old or weak batteries,

batteries can leak chemicals that can
destroy electronic parts.

 If you do not plan to use the detector

for a week or more, remove the

batteries.

 Dispose of old batteries promptly and

properly.

 Please change the batteries when LOW

BAT light is on.

4