Page 1
MICATHERMIC HEATER
OPERATING INSTRUCTIONS
For models: GMH310
Page 2
1. Use only the voltage specified on the rating
plate of the appliance.
2. Keep all objects at least 1 metre from the
front, sides and rear of the appliance. Do not
place appliance close to radiant heat source.
3. Do not operate in areas where petrol, paint or
other flammable liquids are used or stored.
4. Do not insert or allow foreign objects to enter
any ventilation or exhaust opening, as this
may cause an electric shock, fire or damage
to the appliance.
5. Do not operate this appliance with a
damaged cord, plug or after the appliance
malfunctions or has been dropped or
damaged in any manner. Return to a
qualified electrical person for examination,
electrical service or repair.
6. This appliance is intended for household use
only and not for commercial or industrial use.
7. Use this appliance only as described in this
manual. Any other use is not recommended
by the manufacturer and may cause fire,
electrical shock or injury.
8. The common cause of overheating is
deposits of dust or fluff in the appliance.
Ensure these deposits are removed regularly
by unplugging the appliance and vacuum
cleaning the air vents and grills.
9. Do not use abrasive cleaning products on
this appliance. Clean with a damp cloth (not
wet) rinsed in hot soapy water only. Always
removed plug from the mains supply before
cleaning.
10.Do not connect the appliance to mains
voltage until completely assembled and
adjusted.
11.Switch off and use handles provided when
moving.
12.Do not operate with cord set coiled up as a
heat build up is likely, which could be
sufficient to become a hazard.
13.The use of an extension cord with this
appliance is not recommended.
14. Do not remove plug from power socket until the
appliance has been switched off.
15. Do not remove plug from power socket by
pulling cord – always grip plug.
16. Always unplug appliance when not in use.
17. Do not twist, kink or wrap the cord around the
appliance, as this may cause the insulation to
weaken and split. Always ensure that all cord
has been removed from any cord storage area
and is unrolled before use.
18. This appliance is not intended for use by young
children or infirm persons unless they have been
adequately supervised by a responsible person
to ensure that they can use the appliance safely.
19. Do not use this appliance in the immediate
surrounds of a bath, a shower, or a swimming
pool or other liquids. The appliance must not be
immersed in any liquids.
20. When the appliance has been unpacked, check
if for transport damage and ensure all parts have
been delivered. If parts are missing or the
appliance has been damaged, contact the
Goldair Customer Services Team. (refer to
details on back page)
21. If your appliance does not work, or is not
working properly, contact the place of purchase
or the Goldair Customer Services Team. (refer
to details on back page). Repair work on the
appliance by unqualified persons can cause
serious risk to the user.
22. There are no user serviceable parts installed in
the unit.
23. Do not put your fingers or other articles into or
near the air inlet or outlet. Do not sit on the unit.
24. Do not place the unit in wardrobes or other
enclosed spaces as this may cause fire hazards.
25. This unit is not supposed to be used in or around
locations where foodstuffs, works of art or
delicate articles of science, etc are stored.
26. Indoor use only.
27. Children should be supervised to ensure that
they do not play with the appliance.
WARNINGS AND SAFEGUARDS
Page 3
OVERVIEW OF GOLDAIR MICATHERMIC HEATER
Your Goldair Micathermic Heater is designed to provide instant personal and background heating. The
Micathermic heating panel self regulates energy consumption thereby minimizing power usage. Micathermic
heating uses both radiant and convection heating technology. Natural convection currents distribute the
heat evenly throughout the room, while radiant heat from the heating surface warms people and objects in
the room. Micathermic heating is extraordinarily safe and reliable as it produces no odours, doesn't burn
oxygen or stir up dust; and has no glowing elements. This heater is equipped with two manual heat settings
and a auto function which allows you to set the desired room temperature and the heat will adjust its output
to maintain this.
1. Heating Source
2. Power Switch
3. Power indicator light
4. Thermostat
5. Feet
1
2
3
4
5 5
FEET ASSEMBLY
Press the feet provided firmly onto the radiator as in the figures below. Ensure the feet are secured with the
screws provided.
Page 4
WALL-MOUNTING FITTING (USED AS FIXED APPLIANCE)
Fitting accessories should be mounted on the wall by screws provided. They should be a distance of 100150 mm away from the floor. It is important to mount the radiator horizontally.
Wall mounting assembly method:
(1) Drill holes on the wall with a distance specified on the figure.
(2) Press the plastic expanded screws into holes and then fixing the brackets on the wall by screwing them
into the holes.
(3) Slide the brackets provided into the Mica heater.
(4) Place the security countercheck on the center of the warmer’s top and fixed it for safety.
CAUTION: never install the radiator directly beneath a socket-outlet or in such a way that people in the
baths, showers or pools may have to touch live parts such as a switch.
Important: The radiator must be connected to an earthed outlet of the appropriate voltage.
IMPORTANT
• Please operate the heater only at the voltage that appears on the label. (220-240V~50Hz 1800W)
• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly
qualified technician in order to avoid a hazard.
• The product is for household use only.
• The heater must not be located immediately below a socket-outlet.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
• Do not use this heater in the immediate surroundings of a bath, shower or swimming pool.
• Do not cover the heater – It is not to be used for drying clothes or textiles by placing them directly over its
surface.
Page 5
TEMPERATURE SETTING
Turn the power switch to the “on” position. Select either the first or second heat setting. You can adjust the
temperature by turning the thermostat knob clockwise to increase and anti-clockwise to decrease the
temperature. The light indicates that the radiator is working. When the required temperature is reached, it
will be automatically maintained by the thermostat.
Important: Do not use the radiator in a room with an area of less than 4m2.
MAINTENANCE
For cleaning ensure that only non-abrasives are used.
IF YOU HAVE PROBLEMS
If the radiator fails to work, contact the manufacturer or supplier.
IMPORTANT! ~ NEVER COVER THIS HEATER!
SUPPORT AND TECHNICAL ADVICE
North Shore City, Auckland, New Zealand
Monday – Friday 8am-5pm
Phone: 0800 232 633
Website: www.goldair.co.nz
Page 6
Your Goldair product has been inspected and tested and is guaranteed subject to the
following for a period to two years from the date of purchase against defects in
workmanship and materials. During this period, such defects will be rectified by
repair or replacement of the product purchased. Your product contains no user
serviceable components and this warranty becomes invalid if in our opinion the
product has been misused, abused, incorrectly installed, tampered with, connected
to an electrical supply not corresponding with the name plate specification, or
subjected to power surges. The warranty does not include any labour or other
associated expense that may be involved in removal or installation of the product.
Normal wear and tear is expressly excluded.
If your Goldair product fails to operate satisfactorily, please return it to the retailer
from whom it was purchased. To obtain a repair or replacement product under this
warranty, you will need to produce satisfactory evidence of date of purchase. The
completed warranty and purchase receipt must be presented with the product. The
warranty should be filled out at the time of purchase. It is in your interest to make
sure this is done.
If the product is to be replaced (cannot be repaired) then that replacement will be of
the same or similar product or accessory excluding packaging, instruction card etc.
Where a replacement product is supplied, this shall be guaranteed for the balance of
the original warranty period.
Any model that is no longer available will be replaced by a model of a value and with
such features as we consider appropriate in the circumstances. Goldair Ltd is not
responsible for freight forwarding charges, losses or damage in transit.
If service is required after the warranty period has expired, the product should be
returned to a qualified electrical technician. Service outside of the warranty period
will be at your cost.
Consumers Guarantee Act (1993).
In accordance with the above act consumers are advised that: The manufacturer
does not undertake that repair facilities and parts are necessarily available for this
product.
If any of the provisions of the foregoing are contrary to any relevant legislation, then
that provision shall be deemed to be excluded from the warranty and the rest of the
provisions will continue to apply.
TWO YEAR WARRANTY
IMPORTANT: PLEASE RETAIN THIS WARRANTY CARD
NAME:
ADDRESS:
PURCHASED FROM:
SUBURB:
DATE OF PURCHASE:
NAME OF PRODUCT:
MODEL No:
.
Loading...