![](/html/db/db21/db216a874484aa3d42630050d66d5d539858ad4e2850e81748ea8bbb5251bdf9/bg1.png)
8 Series (ES8, CS8, CB8) Activity
Monitoring
System
Transmitter Module Installation
Procedure
! Compliance Statement (FCC part 15.19):
This device complies with Part 15 of the FCC rules.
Operation is subject the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
! Caution (Pertaining to FCC part 15.21):
Modifications to this equipment not expressly approved by GOJO Industries, Inc. could void the user's authority
to operate the equipment.
! Compliance Statement/Déclaration de Conformité (IC):
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two
conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) L'appareil ne doit pas produire de brouillage, et
(2) L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
This unit is certified to FCC Part 15 Part C for intentional unlicensed radiators.
FCC ID: 076-T6SG0910A
IC: 10391B- T6SG0910A
![](/html/db/db21/db216a874484aa3d42630050d66d5d539858ad4e2850e81748ea8bbb5251bdf9/bg2.png)
Slide the bottom portion of the cabinet up
Wait 5 seconds for a flashing green LED. If
red or no LED, open the cabinet to check for
incorrectly installed refill or other issues.
Load the dispenser with the
appropriate product refill if
needed.
Press both cabinet latches to release the bottom
portion of the cabinet.
Remove the connector
cover from the pumphouse.
Insert the module into the left side of the
pumphouse, pushing the front face until the
module snaps into place.
Slide the bottom of the
cabinet down to expose
the pumphouse.