The cabinet ........................................................................................................... 15
The drum .............................................................................................................. 16
Remove of your machine from lime ...................................................................... 16
SECTION 7: PRACTICAL INFORMATION ......................................................... 16
SECTION 8: AVOIDING MINOR FAULTS ........................................................... 18
SECTION 9: AUTOMATIC FAILURE DETECTION SYSTEM ............................. 19
SECTION 10: INTERNATIONAL WASHING SIGNS ........................................... 20
ENG - 2
SECTION 1: BEFORE USING
SAFETY WARNINGS
Do not use a multiple socket or extension cord.
•
Do not insert a plug with damaged or broken cord into the socket.
•
If the cord is damaged it should be replaced by the manufacturer or appointed service agent
•
in order to avoid a hazard.
Never remove the plug from the socket by pulling from the cord section. Remove the plug by
•
holding.
Do not plug the power supply with wet hands.
•
Never touch the machine with wet hands or feet.
•
Never open the detergent drawer while the device is running.
•
Never force to open the door of the machine while the machine is running.
•
Since the machine can reach high temperatures while running, do not touch the drain hose
•
and water during draining.
In case of any failure, first unplug the device and close the water tap.
•
Do not attempt to repair. Please apply to the nearest authorized service station.
Do not forget that the packing material of your machine may be hazardous for children.
•
Do not let your children play with the washing machine.
•
Keep your pet away from your machine.
•
Your machine should only be used by adults within the information written in this manual.
•
Your machine is designed for use in house environment. Warranty will be invalid if you use it
•
for commercial purposes.
The appliance should not be put on a carpet which can block the air ventilation on the bottom
•
side.
ENG
RECOMMENDATIONS
The detergent or softener in contact with air for a long time will dry and stick to your detergent
•
drawer.To avoid this put your detergent and softener into the detergent drawer just before
washing.
It is recommended that you use pre-washing program for only very dirty clothes.
•
Please do not exceed the maximum loading capacity.
•
The appliance is not intended for use by people (including children) with reduced physical,
•
sensor yor mental capabilities , or lack of experience and knowledge , unless they have been
given supervision or instruction concerning use of the appliance by a preson responsible for
their safety.Children should be supervised to ensure that they don’t play with the appliance.
If you will not use your machine for a long time, unplug your machine, close the water supply
•
and leave the door open in order to keep the inside of the machine dry and for prevention
from unpleasant odour.
As a result of the quality control procedures, a certain amount of water may remain in your
•
machine. This is not harmful for your machine.
ENG - 3
ENG
SECTION 2: INSTALLATION
You must pay attention to the following issues before using your washing machine.
REMOVAL OF TRANSPORTATION SCREWS
Transportation screws, which are located at the back side of the machine, must be removed
•
before running the machine.
Loosen the screws by rotating counterclockwise by a suitable wrench. (DIAGRAM-1)
•
Remove the screws by pulling them. (DIAGRAM-2)
•
To the holes where the transport screws have been removed, insert the plastic transport
•
screw taps found in the accessories bag. (DIAGRAM-3)
The transportation screws, that have been removed from the machine should be kept in hand
•
for any other transportation necessities.
ADJUSTMENT OF FEET
•
Do not install your machine on rugs or similar surfaces.
•
For your machine to work silently and without any vibration, it should be settled on a flat,
non-slippery and tough ground.
•
You can adjust the balance of your machine from its feet.
•
First, loosen the plastic adjustment nut.
•
Adjust by rotating the feet upwards or downwards.
•
After the balance has been reached, tighten the plastic adjustment nut again by rotating it
upwards.
•
Never put cartons, wooden blocks or similar materials under the machine to balance the irregularities on the level of the ground.
ENG - 4
ELECTRICAL CONNECTION
Your washing machine works with 220-240V and 50Hz.
•
A special grounded plug has been attached to the network cable of your washing machine.
•
This plug must definitely be inserted to a grounded socket with 10 ampere. The fuse flow
value of the electricity line attached to this should also be 10 ampere. If you have no such
sockets and fuses in your house, let it be made by a qualified electrician.
Our company will not be responsible for any damages that may occur as a result of
•
usage without grounding.
Insert the machine’s plug to a grounded socket which you can easly reach.
•
WATER SUPPLY CONNECTION
Your machine has a single water (cold) inlet.
•
To prevent from the leakages on the connection joints, 1 seal is included in the hose
•
packing.(Fit this seal on the end of the water inlet hose at the tap side.)
Connect the end with bracket of the water inlet hose to the water inlet valve at the rear of the
•
machine and the other end to your tap. In situations where you are not assured, let a qualified
plumber make the connection works.
Water pressure of 0,1-1 MPa from your tap will enable your machine to work more
•
efficiently.(0,1 MPa pressure means water flow of more than 8 liters in 1 minute from
a fully opened tap)
After connections are completed, check for the non-leakage of the connection joints
•
by turning on your tap completely.
Be sure that water inlet hoses are not folded, broken or crushed.
•
Mount the water inlet hoses to a 3”/4, geared water tap.
•
ENG
ENG - 5
ENG
WATER DRAIN CONNECTION
Be sure that water inlet hoses are not folded, twisted, crushed or elongated by stretching.
•
Water drain hose should be mounted at a height of minimum 60 cm, maximum 100 cm from
•
the ground.
The end of the water drain hose may directly be fitted to the dirty water outlet hole or a special
•
apparatus mounted on the outlet bracket of the wash-stand.
Never attempt to extend the water drain hose by adding extra parts.
•
WFE1015M8
20
SECTION 3: TECHNICAL SPECIFICATIONS
BrandGoddess
ModelWFE1015M8
Energy classA+
Washing efficiencyA
Spinning efficiencyC
Energy consumption kWh/washing cycle0,85
Water consumption l/washing cycle43
Noise level (washing): dB(A)58
Noise level (spinning): dB(A)77
Voltage/Frekvency (V/Hz)(220-240) V/ 50Hz
Electrical current (A)10
Water presure (Mpa)Max. 1 Mpa/ Min. 0,1 Mpa
Power rating (W)2100
Maximum dry laundry capacity (kg)5
Recommended loading (kg)4,5
Height (cm)85
Width (cm)59,6
Depth (cm)51
Maximum spin cycle ( rpm )1000
ENG - 6
SECTION 4: CONTROL PANEL
WFE1015M8 (3 tlačítka)
1 2 3 4 5
ENG
678
1) Detergent drawer
2) Program knob
3) Program end light
4) Function indicator lights
5) Start/pause light
6) Program ready light
7) Function buttons
8) Start/pause button
Our product has electronic card and soft-touch buttons.
To activate the functions touch the buttons slightly.
ENG - 7
ENG
ENG
START/PAUSE BUTTON
Used to start a selected program or pause during running.
WARNING!
It is required for the program knob to be brought to O (off) position before selecting the program or changing a continuing program.
FUNCTION INDICATOR LIGHTS
When the start/pause button or any function button is pressed, the corresponding light
turns on.The light turns off when the function button or start/pause button is re-pressed, or when the process the selected function is completed.
The function indicator lights are also used in failure detection system mentioned in section 9.
FUNCTION BUTTONS (depends on selected model – see the control panel of your washing machine)
No spin
This program is recommended to be used for your sensitive clothes on which no spinning should be done. By pressing this function button, you can cancel the spinning process which is included in the program.
Prewash
You can expose your very dirty laundries to prewashing operation prior to main washing byusing this auxiliary function. When using this function, you should put detergent in front washingcompartment of the detergent drawer.
ENG
START/PAUSE BUTTON
Used to start a selected program or pause during running.
WARNING!
It is required for the program knob to be brought to O (off) position before selecting the program or changing a continuing program.
FUNCTION INDICATOR LIGHTS
When the start/pause button or any function button is pressed, the corresponding light
turns on.The light turns off when the function button or start/pause button is re-pressed, or when the process the selected function is completed.
The function indicator lights are also used in failure detection system mentioned in section 9.
FUNCTION BUTTONS (depends on selected model – see the control panel of your washing machine)
No spin
This program is recommended to be used for your sensitive clothes on which no spinning should be done. By pressing this function button, you can cancel the spinning process which is included in the program.
Prewash
You can expose your very dirty laundries to prewashing operation prior to main washing byusing this auxiliary function. When using this function, you should put detergent in front washingcompartment of the detergent drawer.
WARNING!
Functions vary depending on the model you have chosen. If you forgot to use additional function and your machine starts to wash push the additional function button if the indicator light is on. Additional function will be activated.If the indicator light is not on, additional function will not be activated.
START/PAUSE BUTTON
FUNCTION INDICATOR LIGHTS
The function indicator lights are also used in failure detection system mentioned in section 9.
FUNCTION BUTTONS
(depends on selected model – see the control panel of your washing machine)
Used to start a selected program or pause during running.
WARNING!
It is required for the program knob to be brought to O (off) position before selecting
the program or changing a continuing program.
When the start/pause button or any function button is pressed, the corresponding light
turns on.The light turns off when the function button or start/pause button is re-pressed,
or when the process the selected function is completed.
No spin
This program is recommended to be used for your sensitive clothes on which no
spinning should be done. By pressing this function button, you can cancel the spinning
process which is included in the program.
Prewash
You can expose your very dirty laundries to prewashing operation prior to main washing by
using this auxiliary function. When using this function, you should put detergent in front washing
compartment of the detergent drawer.
Note: Supplementary function „Prewash“ is not available for all programs. It can be used
for programs Cotton 90, Cotton 60, Cotton 40, Synthetic 60, Synthetic 40.
The „Prewash“ function extends the wash time approx. by 15-20 min. Includes additional
wash cycle before the main wash (washing in cold water for programs Cotton 90, Cotton
60, Cotton 40, and washing at 30 ° C for programs Synthetic 60 and Synthetic 40).
Using the function Prewash you can achieve very good wash results without the laundry
pre-soaking.
WARNING!
Functions vary depending on the model you have chosen. If you forgot to use additional
function and your machine starts to wash push the additional function button
if the indicator light is on. Additional function will be activated.If the indicator light is not
on, additional function will not be activated.
ENG - 8
Loading...
+ 16 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.