Gocom GO100 User Manual
Features�
Turn�Radio�On�and�Off
GO100
TWO-WAY�RADIO
User�Manual
Keypad�Control�and�Function�
Antenna
●���9�Channels�
●���Up�to�1.5km��range
●���5�call�tones�for�selection�
●���Call�Roger�Tone�
●���Keypad�Tone�
●���Auto�power�off�(1.5h)�
●���Keypad�Lock�
●���Auto�Squelch�Control
●���Battery�Save�
●���Low�Battery�Alert
●���TOT�(time-out�timer)�
●���Volume�(0-7)�
Installing�the�Batteries
1.�Remove�the�battery�cover.
2.�Insert�3�AAA�Alkaline�Batteries�with�+�
���and�-�polarity�as�shown�inside.
3.�Close�the�battery�cover�firmly.
1.�Press�and�hold�[��]�key�for�3�seconds�to�
���turn�the�radio�on�or�off.�
2.�Upon�power�on,�the�radio�chirps�and�
���briefly�shows�all�feature�icons�available�
���on�the�radio.
3.�The�display�screen�then�shows�the�
���current�channel,�and�all�features�that�
���are�enabled.
1
Setting�the�Volume
1.�Press�VOL[▲]�key�to�increase�the�
���volume�level.
2.�Press�VOL[▼/��]�key�to�decrease�the�
���volume�level�or�mute�the�speaker.
Channel+�key
Channel-�key/Call�tone�key
PTT�key
Note:�LED�only�displays�the�channel�
LED�display�
ON/OFF�key�
Volume+�key�
Volume-�key/Lock�key�
Microphone�
Speaker
���NOTE:�
Auto�Power�Off
If�there�is�no�
response�in�1.5�hour,�
the�radio�will�turn�off�
automatically.
���Do�not�hold�the�radio�close�to�your�
���ear,�if�the�volume�is�set�to�
���uncomfortable�level,�it�could�hurt�you�
���hear.
2 3
Selecting�the�Channel�
The�channel�is�the�frequency�of�radio�
uses�to�transmit.
1.�Press�CH�[▲]�key�to�increase�the�
���channel�number.
2.�Press�CH�[▼/��]key�to�decrease�the�
���channel�number.
3.�The�radio�has�9�channels.
Talking�and�Listening��
All�radios�in�a�group�should�set�to�the
same�channel.�
1.�Press�and�hold�[Talk]�key�while�
���speaking.�
2.�Release�[Talk]�key,�you�can�now�
���receive�the�incoming�calls.�
3.�For�maximum�clarity,�hold�the�radio�2�
���to�3�cm�away�and�avoid�covering�the
���microphone�while�talking.
Talk�Range
Your�radio�is�designed�to�maximize�
performance�and�improve�transmission�
range.�
NOTE:�
Do�not�use�the�
radio�closer�than�
five�feet�apart.�
Talk�Timeout�Timer
To�prevent�accidental�transmissions�and�
save�battery�life,�the�radio�emit�a�
continuous�warning�tone�and�stops�
transmitting�if�you�press�the�[Talk]�key�
for�60�seconds�continuously.
Setting�and�Transmitting�
Call�Tones�
Your�radio�can�transmit�different�call�
tones�to�other�radios�in�a�group�so�you�
can�alert�them�that�you�want�to�talk.
1.�Press�and�hold�CH[▼/��]key�for�2�
���seconds�to�transmit�the�call�tone,�press�
���and�hold�CH[▼/��]key�for�2�seconds�
���again�to�transmit��������the�next�call�
���tone.
2.�The�radio�has���������5�call�tones.��
4
Battery�Save Frequency�Table�
Roger�Tone�
Your�radio�transmit�a�unique�tone�when�
you�finish�transmitting,�it�is�like�saying�
“Roger”�or�“Over”�to�let�others�know�
you�have�finished�talking.
Keypad�Lock�
To�avoid�accidentally�change�your�radio�
settings.
1.�If�there�is�no�response�in�10�seconds,�
���the�radio�will�lock�the�keypad�
���automatically.
2.�You�can�also�press�and�hold�VOL�
���[▼/��]�key�to�lock�or�unlock�the�keypad�
���manually.
5
Battery�Save�function�works�
automatically�to�save�battery�life.
Your�radio�is�idle�inactive�for�5�seconds,�
it�will�enter�battery�save�mode�
automatically.�Under�this�mode,�the�
walkie-talkie�can�receive�incoming�calls.
Low�Battery�Alert
When�the�battery�power�is�low,�the�radio�
chirps�periodically(Low�Battery�Alert).�In�
battery�low�status,�the�radio�will�sound�
the�alert�every�5�minutes�or�after�
releasing�the�[Talk]�key.
NOTE:�
Remove�the�battery�from�radio�for�
storage�purposes.
Email:securitygold@sina.com�
Web:www.hqjmtech.com
Frequency�of�America�
Channel
1 462.56250 4 462.63750 7 462.71250
2
3
6
Frequency
462.58750
462.61250
Channel
5
6
Frequency
462.66250
462.68750
Channel
8
9
Frequency
467.56250
467.58750
7
Loading...