Gobo ECO SPOT C40, ECO SPOT C60 User Manual

ECO Spot LED C40/C60 User Manual

ECO Spot™ LED C40/C60 User Manual

experience in lighting equipment and general electrical experience.

uilding and electrical codes and

defective or wet, or if they show signs of overheating.

Thank you for choosing an ECO Spot™ Gobo projector. This manual
covers the ECO Spot C40 and ECO Spot C60.

Please read this manual before installing or operating this fixture,
follow the safety precautions listed below and observe all warnings.

Package Contents

 Projector with power cord
 Test Gobo
 Spare gobo retaining ring and drive belt
 Gobo adapter for D- to E-Size gobos with retaining ring

Safety Information

• Place your fixture at a suitable place with good air flow.

• Keep flammable materials away from the fixture.

• Minimum distance to flammable material = 1 ft (0.3m).

• Provide a minimum clearance of 4 in (10cm) around air vents.

• Use only genuine spare parts for part replacement.

• Do not look directly into the lamp; it can result in eye damage.

• Always unplug the unit from the power mains before any service is done.

• Light fixtures should be installed and maintained only by qualified personnel with

Electrical Safety

• Disconnect the fixture from AC power before handling the fixture.

• Always ground (earth) the fixture electrically.

• Use only a power source that complies with local b

has both, overload and ground-fault protection.

• Do not use the fixture if the power cable or power plug is in any way damaged,

Warranty

One Year from Date of Purchase. Keep your receipt for reference and

contact your dealer in case of warranty issues.

Copyright © 2017 Globus New Media LLC Page 1

ECO Spot LED C40/C60 User Manual

can hold

an approved means of secondary attachment such as a safety cable.

is well focused.

When used for the first time, the lens will often need to be twisted outwards many

• Re-adjust the focus if necessary.

• The yoke can be screwed to a wall or ceiling or fastened with a C-clamp

Handling Instructions

• Before the initial start-up, please unpack and carefully check for damage caused

during transportation.

• Place your fixture at a suitable place with good air flow.

• Make sure there are no flammable materials close to the lamp.

• When suspending the fixture above ground level, verify that the structure

at least 10 times the weight of all installed devices.

• Verify that all external covers and rigging hardware are securely fastened and use

Projection Lenses

The projector accommodates interchangeable projection lenses to allow optimizing the
projection size and resulting brightness at varying distances. The more narrow the lens,
the smaller and brighter the image will be at a given distance.

Focusing

• Power up the projector by pressing the power switch in the back.

• Focus the projection by twisting the lens in and out until the image

rotations to reach the focusing point.

• Turn on the gobo rotator with the push-button in the back and switch it off when

the gobo projects in the desired position.

Gobo Rotator

The gobo rotator can be turned on/off with the push-button switch on the back plate.

There are no controls for rotating speed or direction.

Dimming

If equipped, the projection brightness can be adjusted with the manual dial on the back
plate.

Multi-functional Yoke

• The yoke can slide over the whole length of the fixture body to accommodate a

wide range of pointing directions.

• The yoke serves as stand.

Page 2 Copyright © 2017 Globus New Media LLC