Glunz & Jensen Flex-In-One 260 Preinstallation Manual

Pre-installation Manual

Flex-In-One 260

Pre-installation Manual

Flex-In-One 260

Edition AA, December 2015

This book has part No 10082662

T11376

Flex-In-One 260

This manual is published by: Glunz & Jensen S.p.A.

Via Alessandro Volta 28
20088 – Rosate (MI) – ITALY
Tel.: [phone] – Fax: [phone]
Internet: www.degraf.glunz-jensen.com

Copyright © 2015 by Glunz & Jensen S.p.A.

Pre-installation Manual - Flex-In-One 260 1549

0-2

Part 0: Introduction

Reservations

•

This manual was written and illustrated using the best possible information
available at the time of publication.

•

Any differences between this manual and the equipment reflect improvements
introduced after the publication of the manual.

•

Changes, technical inaccuracies and typographic errors will be corrected in
subsequent editions.

•

As a part of our policy of continuous improvement, we reserve the right to alter
design and specifications without further notice.

Pre-installation instructions

The instructions in this Pre-installation Manual allow the customer and the Service
Technician to prepare the installation site for the equipment and for the installation
itself.

•

Never install the equipment in explosive environments.

•

It is the responsibility of the owner and operator/s of the equipment that the
installation is made in accordance with local regulations, and by engineers
authorized to carry out plumbing and electrical installations.

•

The manufacturer cannot be held responsible for any damage caused by incorrect
installation of the equipment.

"

Only qualified Service Technicians are allowed to unpack and install the
equipment.

#

When preparing the installation site please take into consideration that this
equipment is for restricted access locations only!

Notes, cautions, and warnings !

Throughout the manual warnings, cautions, and notes are written in bold like the
example below:

#

Electrical installation must conform to local regulations and guidelines.

Symbol Meaning Explanation

"

Note

The operator should observe and/or act according to the
information in order to obtain the best possible function of the
equipment.

$

Caution

The operator must observe and/or act according to the
information in order to avoid any mechanical or electrical
damage to the equipment.

#

Warning

The operator must observe and/or act according to the
information in order to avoid any personal injury.

1549 Pre-installation Manual - Flex-In-One 260

0-3

Introduction

Table of contents

Pre-installation Manual - Flex-In-One 260 1549

0-4

Introduction

Table of contents

Part 0: Introduction .................................... 0-3

Reservations ..................................................0-3

Pre-installation instructions ........................................0-3

Notes, cautions, and warnings ! .....................................0-3

Part 1: Transportation .................................. 1-1

When the equipment arrives .........................................1-1

Storing the equipment before installation ..............................1-1

The crate.......................................................1-1

Dimensions and weight...........................................1-1

Checking the crate for damage......................................1-2

Handling the crate ..............................................1-2

Transporting the equipment ..........................................1-3

Lifting the crate ................................................1-3

Available width for transport .......................................1-3

Part 2: Installation requirements ........................... 2-1

Environmental requirements .........................................2-1

Accessories to be provided by customer for connections ......................2-1

Installation kit ...................................................2-1

Space requirements ...............................................2-2

Free space around the equipment ...................................2-2

Equipment dimensions and connection locations .........................2-3

Electrical requirements .............................................2-5

Main power connection...........................................2-5

Main power outlet ..............................................2-5

Power supply cable .............................................2-5

Electrical specifications ...........................................2-6

Fuses .......................................................2-6

Power consumption .............................................2-6

Part 3: Pre-installation checklist ...........................3-1