Global Test Supply Aurora TGZ370 Owner's Manual

6" All Stainless

Electronic Digital Caliper

OWNER’S MANUAL

FOR YOUR SAFETY AND CARE OF THIS TOOL,

please read these instructions carefully and retain them for future use.

CARE AND MAINTENANCE

1. Keep body face clean, prevent liquid material from getting into slider to destroy electronics.

2. Face should be cleaned with a clean, dry, lint-free cloth. Lubricate body with a few drops of

clock oil. Acetone and alcohol must not be used.

3. Keep battery compartment clean and free of corrosion.

TROUBLESHOOTING

PROBLEM/

Every second 5 digits
jump simultaneously

Display cannot count

Display shows 000.00
or IN 00.000

Function buttons not active

Reading error for full
length is ≥ 0.1mm

No display on LCD screen

SOLUTION/

Battery voltage is under 1.45V.
Remove cover and replace battery.

Faulty circuit. Remove battery, after 30 sec.
put battery back into compartment.

Function buttons and sliders signal end may have
shorted out. Remove the cover, put the button springs in
place with rubber covers. Contact must be unobstructed.

Springs or rubber covers may be out of shape due to
excessive pressing. See solution above for tips.

Sensor may have dirt or deposits in it. Remove cover
and slider assembly. Blow off sensor face with clean
pressurized air ≥ 51kg/cm squared), clean with a dry,
lint-free cloth.

1. Poor battery contact.
Check battery compartment, clean if necessary.

2. Battery voltage is under 1.3V.
Replace with correct battery.

GUIDE D’UTILISATION

No. TGZ370

www.GlobalTestSupply.com

Find Quality Pro ducts Online at: sales@GlobalTestSupp ly.com

Repeatability:

0.01mm or 0.0005"
Maximum measuring speed:

1.5m/sec or 60"/sec
Measuring system:

Non-contact linear

CAP measuring system
Display:

LCD display, minus sign "-", character in

6.35mm/0.25" height for 5 digits,

small digit "5" and "IN" sign for

inch measuring unit
Battery:

One silver oxide battery 1.5V type LR44

for one year of continuous use;

low battery warning by flashing display
Operating temperature:

0°C ~ +40°C
Storage temperature:

-20°C ~ +70°C
Influence of humidity:

Not important within 0 to 80%

of relative humidity

Auto power off

On/Metric/Inch change over
(true conversion)

Off Switch

Zero setting (zero setting
at any position within the
measuring range)

Battery compartment cover

PRESS

SPECIFICATIONS AND FUNCTIONS

Your digital caliper was constructed with
quality materials and workmanship, and
will give you many years of trouble free
use when cared for as described in the
"Care & Maintenance" section.

CALIPER FEATURES

CALIPER APPLICATIONS

MEASURING RANGE:

0-150mm / 0 - 6"

RESOLUTION:

0.01mm / 0.0005"

Measurements of external dimensions

Measurements of internal dimensions

Measurements of depth

Differential method measurement (application of zero setting)

20

20.02

www.GlobalTestSupply.com

Find Quality Pro ducts Online at: sales@GlobalTestSupp ly.com