GlobalSat TR-151 Quick Start Guide

USB Connector
Microphone
Power Button
Emergency Button
LED Indicator
Quick Start Guide
External Antenna
TR-151
LED Indicator
A B C D
A
GSM LED
Blink Quickly (Once per second) Blink Slowly (Once every 3 seconds)
LED
1.No SIM card inserted
State
2.TR-151 is searching GSM network
3.SIM card is registering to GSM network
B
GPS LED
Keeps On Blink Slowly (Once every 3 seconds)
LED
1.TR-151 does not get GPS fix
State
2.TR-151 is trying to get GPS fix
C
Status LED
Keeps On Blink
LED
State
Battery low
1
time
TR-151 is being turned off.
2 TR-151 is being turned on.
times
Standby Mode
TR-151 gets GPS fix
times
3 SOS button is pressed
times
5 Error occurs
Power LED
D
Orange Off
LED
TR-151 is connected to charger or USB
State
cable
SIMPLE TRACKER TR-151 01.
LED goes off after the battery has been fully charged.
Device Operation
Charge the device
Install SIM card
Unscrew TR-151 by screwdriver. Lift up the back cover.
Before using TR-151 for the first time, please charge it by connecting to AC power adapter under the power-off condition at least 4 hours. You can also charge the TR-151 by connect it to PC or Notebook via USB cable. (The power of PC or of notebook should be turned on.)
Note: The attached battery is specially designed for TR-151. Please do not use other type of battery; otherwise it will damage the device. If you need to change the battery of TR-151, please contact your local dealer
1.
2.
ON
1 2 3 4
-Push forward the cover of SIM card slot to the position marked with “OPEN”. Then lift up the cover
-Insert the SIM card with its metal contacts facing down and the cut corner at the top left.
SIMPLE TRACKER TR-151 02.
-Please make sure DIP switch 3 is at Off position.
-If DIP switch 3 is at On position, please turn it at Off position with the sharp-pointed stuff.
Install Battery
Red
Yellow
Black
Plug the battery connector into socket. Be aware that the red wire must be plugged on the top side.
Please put the connector wire under the battery, and then put the battery into battery compartment.
NOTE:
After installing the battery, the status LED will emit red light. After the LED go out, please wait for 5 seconds before turning on the power. Please take out the battery if you do not use TR-151 for a long time.
SIMPLE TRACKER TR-151 03.
Turn on/off TR-151
- You could turn on the device by pressing and holding the power button until you
see status LED [ ! ] blink 2 times.
- You could turn off the device by pressing and holding the power button until you
see status LED [ ! ] blink 1 time.
Emergency button
- You could press emergency button until you see status LED [ ! ] blink 5 times.
TR-151 will try to get GPS fix and then send out the emergency SMS to preset
phone number.
SIMPLE TRACKER TR-151 04.
Loading...