Wrist GPS Training Device
GH-625XT
Quick Start Guide
Version
3.0
This version is usage for Firmware Version 2.02 or above
http://www.gs-sport.com
What is GPS?
GPS stands for Global Positioning System. For 3D fix, we need at least four satellites.
Normally the accuracy of GPS under open sky which means no tall building and clear sky is
within 10 meters per second. Therefore, if the device shift 10 meter at that second, the device
may shows 36 kilometer per hour instant speed. Nowadays, the GPS consumer product has
built in adjust algorithm and assisted method to extend capability of GPS.
What is IPX7?
Protected against the effects of temporary immersion in water. Under specific
conditions of pressure and duration, water must not enter a
temporarily submerged headlamp in quantities that would cause adverse
operational effects.
The IPX7 waterproof standard is for device one meter under water within 30
minutes protection. Waterproof standards usually measure by the pressure of water.
IPX7 standard provides device protection to be exposed the rain and sprayed over
water. However, the pressure of swimming or diving should exceed IPX7 standard.
Note for Upgrading Firmware
Do not interrupt during upgrading the firmware
When the upgrading firmware fail, please go over the process again
Choose the firmware file carefully
CAUTION !
Before connecting to device, please be aware of the direction
Before first time using watch, please fully charge the device.
Please dry the clip before connection of charging or data transfer.
Before start training, please let antenna face to sky to get 3D fix
Battery capacity
indication
The remaining battery power
When you stop the timer, the icon will be
flashing. If it is auto paused, you will see
the icon flashing
This icon will show up when you set the
alarm clock for WEEKEND, WEEKDAY,
DAILY…or OFF
GPS status indicator
Flash: No signal
Solid: 3D fix
Heart Rate Alarm
Zone indicator
There are three numbers to indicate Heart
Rate Alarm Zone, press PG for 5 sec to
switch.
Configure Personal Setting Before
Training
Before get training, you may configure your personal parameter to get more accurate result.
Or you may set it through PC software.
[MAIN MENU] > [CONFIGURATION] > [PAGE SETTING ]
1. Press ‘’Page button’’ to select
CONFIGURATION menu.
2. Chose ‘’USER PROFILE’’ then press
‘’Enter button’’. Press “ESC button” to
escape once finish.
How To Set Up Custom Page
Set up the custom page and function list before your training.
[MAIN MENU] > [CONFIGURATION] > [PAGE SETTING ]
1. Press ‘’Page button’’ to select
CONFIGURATION menu.
2. Chose ‘’PAGE SETTIN G’’ then press
‘’Enter button’’.
3. T o define the interest page to set how
many windows to show information.
4. Select the function coefficient you want
then press ’Enter button’’ to save
setting.
Press ‘’ESC/LAP button’’ to exit or ‘’Page
button’’ to go back to main menu