Bluetooth GPS Set-Up Guide
1. WINDOWS XP
2. POCKET PC 2003
3. POCKET PC WM5
4. PALM
5. MAC OSX 10.3 or OLDER
6. MAC 10.4x TIGER
7. CONTACT INFORMATION
8. LIMITED WARRANTY
DOCUMENT REVISIONS
REV NO. DATE DESCRIPTION APPROVED
1.0 04-16-2006 Initial document AAK
BT-338 GPS
1. WINDOWS XP BLUETOOTH GPS SET-UP
To set up a Bluetooth connection with your Globalsat GPS receiver, follow these steps:
1.
Tap the Bluetooth icon in the lower-right corner of the screen
2.
Select “Turn radio ON”
3.
Tap the Bluetooth icon again and select “Add a Bluetooth Device”
4.
Check “My Device is set up and ready to be found” in the “Add Bluetooth Device Wizard” and
click "Next".
5.
Select "New Device" from the displayed Bluetooth devices and tap “Next”.
6.
Tap “Use the passkey found in the documentation".
7. Enter the Passkey Code (or PIN code) for the GPS receiver and select "OK"
(For the BT-308 passkey code is
8.
Bluetooth Manager will display and designate an Outgoing and Incoming port for your device.
2003
and for
the BT-338 & BT-328 GPS receivers it’s
(NOTE: Utilize the Outgoing port for third party navigation application port configuration.)
9.
Select "Finish" to complete Bluetooth device configuration.
NOTE:
In most cases, mapping and navigation software require you to manually configure the assigned COM
port of the GPS receiver in order to properly communicate and retrieve the GPS data
User Guide for more details on assigned COM ports and you navigation User’s Guide on how to properly
configure the GPS COM port to be read.
0000)
. See your PDA’s
2. POCKET PC 2003 BLUETOOTH GPS SET-UP
To set up a Bluetooth connection with your Globalsat GPS receiver, follow these steps:
1. Tap the Bluetooth icon in the lower-right corner of the screen
2. Select “Turn radio ON”
3. Tap the Bluetooth icon again and select “Bluetooth Manager”
4. Tap “Yes” in the “Bluetooth Manager” window
5. Select the proper Bluetooth GPS receiver and tap “Save”
6. Tap “OK” to save the GPS to the “All devices” group
7. Tap “OK”
8. Tap the proper Bluetooth GPS icon
9. Go to “Actions” and tap “Create bond with this device”
10. Enter the Passkey Code (or PIN code) for the GPS receiver and select "OK"
(For the BT-308 passkey code is
11. Close the “Bluetooth Manager” window
12. Launch your third-party navigation application.
2003
and for
the BT-338 & BT-328 GPS receivers it’s
NOTE:
In most cases, mapping and navigation software require you to manually configure the assigned COM
port of the GPS receiver in order to properly communicate and retrieve the GPS data
User Guide for more details on assigned COM ports and you navigation User’s Guide on how to properly
configure the GPS COM port to be read.
. See your PDA’s
0000)
PAGE 2 OF 6
Bluetooth Installation Quick-Start Guide_1.0
Loading...