User Manual
Frs Walkie Talkie
EN USER INSTRUCTIONS
1 Instruction For Use
This set includes 2 walkie-talkie units which are
communication devices operating on 462MHZ.
They come with 3 channels, enabling you to
communicate up to 2 Miles(3KM) in open areas.
Note: Please read the user manual carefully before
using the equipment and retain for future consultation!
Specific Recommendations
⚫ If you carry any kind of personal medical device,
Please consult a doctor before use.
⚫ To avoid the risk of burns, do not use the device if
The aerial is damage in any way.
⚫ Do not use the device in a potentially explosive
setting (e.g. Around pumps, on the lower deck of a
boat or around a fuel-storage installation.
⚫ Switch off the device if on an airplane or in a hospital.
⚫ Never use the device in close proximity to a radio that
avoid to interference.
⚫ Never mix used and new batteries.
⚫ Position the transmitter and antenna ≥5cm from your
face. Direct the antenna upwards and speak normally.
⚫ Clean the device with a damp cloth. Don’t use agents
and solvent for cleaning.
⚫ Do not modify the device in any way. In the event of
damage occurring, ensure that the device us checked
by a qualified professional.
⚫ The device cannot be used to contact the emergency
services.
2 Key Functions
3 Before Use the device
3.1 Removing the belt clip
Before insert batteries into the device, first remove the
belt clip latch away from the device.
3.2 Open the screw with a screwdriver
Note: Children under Age 12 should open the screws
under adult’s supervision.
3.3 Installing the Batteries
A, FOR USING OF RECHARGEABLE BATTERIES WITH USB CABLE(Included)
1, If the device comes with rechargeable battery and USB
cable, you should use rechargeable batteries to charge.
It cannot charge non-rechargeable batteries.
2, After placing batteries into correct positions,
replace the battery cover.
3, Close the screw with a screwdriver. (Note: Children under
Age 12 should open the screws under adult’s supervision)
4, The fully charging time is about 12hours.
A, FOR USE OF NON RECHARGEABLE BATTERIES(Not Included)
1, Slid down the battery compartment cover.
2, Insert 3* AAA dry batteries (not included)
3, Position the batteries according to the polarity making
on the battery compartment.
4, After placing batteries into correct positions, replace the
battery cover.
5, Close the screw with a screwdriver. (Note: Children under
Age 12 should open the screws under adult’s supervision)
4 Using the device
4.1 Turning the device on/off
Switch on the device: Press and hold on the /VOL for 3
seconds then you will hear a beep sound.
Switch off the device: Press and hold on the /VOL for 3
seconds then you will hear a beep sound.
4.2 Changing Channels
Press the CH button for 2 seconds, the Channel number
will change from 1-3. In order to fix the channel, the
devices set to press the CH button for 2 seconds, then
change to the next channel)
Note: if no button is pressed within 6 seconds during
setting, the device will return to stand-by mode.
4.3 Receiving/transmitting communications:
The devices are in “Reception” mode when it is turned
ON and no transmitting. When a signal is received on the
current channel, the device will in reception.
When you press the PTT (push to talk) button, the
devices switches to “Transmission” mode. The current
digital number will flash in transmitting mode.
Hold the device in a vertical position with the microphone
3-5cm away from your mouth. While holding the PTT
button, speak into the microphone in a normal tone of
voice.
Release the PTT button when you finish transmitting.
For others to receive your transmission, they must be on
the same channel with you.
Note: 1, The talking range depends on your surroundings
and environment. It will be affected by obstructions such
as hills or buildings.
2, Don’t try to use two devices which are less than 1.5m
(5 feet) apart. Otherwise, you may experience interference.
4.4 Sending a call tone
Press the PTT button twice time continues, the call tone will
be transmitted on the setting channel.
5 Technical specifications
Frequency 462MHZ
Channel number 3 channels(with 88.5Hz CTCSS
in each main channel)
Transmission Power ＜0.5Watts
Range Up to 2 Miles(3 Km)in open field
6 Channel and Frequency (MHz)
USA
Changes or modifications not expressly approved by the party responsible
for compliance
could void the user's authority to operate the equipment.
RF Exposure Information:
This product is compliance to FCC RF Exposure requirements and refers to
FCC website https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm search for FCC
ID: 2AMEAYYTWT to gain further information include SAR Values.
This device was tested for typical body-worn operations with the back/front
of the device kept 0cm from the body and 2.5cm from the face.
Ch. Frequency
1 462.5625
2 462.5875
3 462.6125
Loading...