GLOBAL MEI CHUANG T38 User Manual

Operating instruction

0.5Watts Handheld Walkie Talkies

Model NO.: T38

This set included 2 walkie-talkie units: there are communication devices which
operate on mobile on mobile radio frequencies. They come with 8/22(option)
channels as well as back-lit LCD screen, enabling you to communicate over
several kilometers free-of –charge(up to 6KM in open areas).
Note: Please read the operating instructions carefully before using the
equipment and retain for future consultation!

Specific Recommendations
 To avoid the risk of burns, do not use the device if the aerial is damage in

any way.

 Don not use the device in a potentially explosive setting(e.g. Around pumps,

on the lower deck of a boat or around a fuel-storage installation or chemical
products)

 If traveling in a car or by bike, stop before using the device.
 Switch off the device if on an airplane or in a hospital,
 Never use the device in close proximity to a radio that avoid to interference.
 Remove the batteries if the device is not use for an extended period of time.

Never mix used with new batteries.

 Position the transmitter and antenna at least 5cm from your face. Direct the

antenna upwards and speak normally.

 Clean the device with a damp cloth. Avoid the use of cleaning agents and

solvents.

 Do not modify the device in any way. In the event of damage occurring,

ensure that the device us checked by a qualified professional.

 The device cannot be used to contact the emergency services.

Key Functions

Before Use the device

Removing the belt clip

Before insert batteries into the device, first pull the belt clip latch away from the
device.

Installing the Batteries

A, FOR USE OF NON RECHARGEABLE BATTERIES:

1, Slid down the battery compartment cover.
2, Insert 3* AAA Alkaline (Not included)
3, Position the batteries according to the polarity making on the battery
compartment.
4, After placing batteries into correct positions, replace the battery cover.

B, FOR USE OF RECHARGEABLE BATTERIES WITH USB CABLE AND ADAPTER
1, If your walkie talkie comes with rechargeable battery pack, USB cable and
USB adapter or USB car charger, you should only use the battery pack provided
to charge. It cannot charge other type rechargeable batteries.
2, After placing batteries into correct positions, replace the battery cover.
3, The fully charging time is about 12hours.

Using the device

1, Turning the device on/off

Switch on the device: Press and hold on the 3 seconds then you will hear a
beep sound.
Switch off the device: Press and hold on the 3 seconds then you will hear a
beep sound.

2, Adjusting the volume

To increase the volume, press the Up ▲ button. And press the Down ▼ button
to decrease the volume.

3, Low Battery Indication

The device can detect the low battery level when the battery voltage goes low.
When battery voltage is low, the battery icon will flash and a beep will be heard
to indicate that the batteries need to be replaced.

4, Receiving/transmitting communications:

The devices are in “Reception” mode when it is turned ON and no transmitting.
When a signal is received on the current channel, the LCD will display in
reception.
When you press the PTT (push to talk) button, the devices switches to