Page 1
New Product Release
ACALN
AC AllNailer
Page 2
Key Features & Benefits
9300w Motor Ample power for a wide range of applications
9 Wide Range of Nail Will ensure the right nail for the job every time
Compatibility
9Magnesium Construction Both the top and lower guards are magnesium
constructed for maximum strength, durability and
lighter weight.
9Powerful Jaws Ensures the nail does not shift during operation
9Variable Impact Speed For greater operator control and safety
9Rubber Over-Moulded Grip Offers increased operator safety with reduced
fatigue over extended use.
9AC On Neon Indicates when power is available for increased
safety
ACALN – AC AllNailer
Page 3
Key Features & Benefits
Quick Release Jaws
4 Stage
Depth Control
Magnesium Gear Case
Nail / Jaws
Release Control
Variable Impact
Trigger
Rubber Over-moulded
Grips
Quick Access Brushes
Only 2.7kgs
AC Available
Neon
ACALN – AC AllNailer
Page 4
Key Features & Benefits
Say Goodbye To Bent Nails
GMC introduces the AC big brother to the cordless AllNailer model released in
2006. With corded power, the operator now experiences no down time and
increased performance.
As with the DC version (battery powered) the ACALN
does not require special collated nails and is
compatible with a wide range of conventional loose
nails commonly found in your workshop. This includes
twisted galvanised nails for decking right through to
bullet headed construction nails.
The ACALN as some may expect does not shoot nails
It actually drives them in by an internal anvil striking the nail head a t high speed
similarly to a hammer would and there-for much safer than air nailers. This
design also ensures the nails are driven straight and will not bend the nail.
The 4 depth settings will ensure the job is done faster as each nail is driven to a
preset depth every time.
ACALN – AC AllNailer
Page 5
Typical Applications
Click Here to view the application video
http://www.youtube.com/watch?v=vLSidEaPOxM
ACALN – AC AllNailer
Page 6
Specification Sheet
Technical Specifications
Input Power 300watts
No Load Speed 0-16,000rpm
Impact Frequency 0-5,500bpm
Depth Settings 4
Max Nail Angle 45deg
Nail Range Up to 150mm (in soft Woods
Max Nail Head Diameter 10mm
Net Weight 2.7kgs
Warranty 2 Year Repair or Replacement
ACALN – AC AllNailer
Page 7
Frequently Asked Questions
Q: Do I need to use special nails?
A: No. You can use any loose nail within the range specifications
Q: Can I run the tool continuously?
A: No. at stated in the manual, it’s 10sec on and 10 sec off/rest
Q: Will the depth control be the same for all materials?
A: No. The same setting will vary depending on depth, nail spec and material.
You should do a couple of test runs first.
Q: Is the ACALN suitable for finishing projects?
A: Not if you are not countersinking and filling the nail heads as their will be
some very minor marks left after each nail.
Q: Does the tool actually shoot nails out?
A: No. It works similarly to a hammer, where an internal mechanism impact the nails
head at high speed to drive the nail in.
Q: Sometimes the nails are not driven in all the way as per the nail range specification.
A: Even same species of timber can have varying densities and the nail range specified
can there-for be a guide only.
ACALN – AC AllNailer
Loading...