global lift corp Rotational Series, R-375 Owner's Manual

GLOBAL LIFT CORP

Owner’s Manual

Rotational Series

R-375

Dec 2012 Page 1

684 N Port Crescent Rd

Suite C

Bad Axe, MI 48413

Toll Free: 866-712-0606

Fax: [phone]

www.globalliftcorp.com

ROTATIONAL SERIES POOL LIFTS

R-375

TABLE OF CONTENTS

INTRODUCTION PAGE – 3

ADA GUIDELINES FOR PLACEMENT PAGE – 4

24 VOLT BATTERY SYSTEM/WITH CONTROLS PAGE – 5

ROTATIONAL SERIES OPERATING INSTRUCTIONS PAGE – 6

UNIT MAINTENANCE AND CARE PAGE – 7

TROUBLESHOOTING PAGE – 8

TROUBLESHOOTING FLOW CHART

WARRANTY INFORMATION PAGE – 9/10/11

WARRANTY REGISTRATION PAGE - 12

NEW CONSTRUSTION/SLEEVE CUT INSTALLATION R-375

RETRO FIT INSTALLATION R-375

FIXED ANCHOR INSTALLATION R-375

OUT OF BOX INSTALLATION

SEAT INSTALLATION

Dec 2012 Page 2

INTRODUCTION

Your Number One Choice for

Commercial Pool Access Equipment

Global Lift Corp. is located in Mid-Michigan, Global Lift Corp. prides itself in manufacturing top of line

quality aquatic access equipment. Global Lift Corp's key staff has a century of combined industry

experience and we take pride in each and every product that we build. Our Company is ISO Certified

and our products are manufactured in the United States. Global Lift Corp uses only the finest materials

and processes to provide our customers with the highest quality products while still maintaining a

price competitive edge.

Dec 2012 Page 3

ADA GUIDELINES FOR POOL LIFT PLACEMENT

1. Pool Lift Location. Pool lifts shall be located where the water level does not exceed 48 inches

(1220 mm).

2. Seat Location. In the raised position, the centerline of the seat shall be located over the deck

and 16 inches (405 mm) minimum from the edge of the pool. The deck surface between the

centerline of the seat and the pool edge shall have a slope not steeper than 1:48.

3. Clear Deck Space. On the side of the seat opposite the water, a clear deck space shall be

provided parallel with the seat. The space shall be 36 inches (915 mm) wide minimum and

shall extend forward 48 inches (1220 mm) minimum from a line located 12 inches (305 mm)

behind the rear edge of the seat. The clear deck space shall have a slope not steeper than

1:48.

4. Submerged Depth. The lift shall be designed so that the seat will submerge to a water depth

of 18 inches (455 mm) minimum below the stationary water level. To make sure the lift has

enough clearance the lift should be installed at a location with 48” of Water depth

Dec 2012 Page 4

24 VOLT BATTERY SYSTEMS WITH CONTROLS

All of Global Lift Corp’s Rotational Series Lifts are equipped with a sealed
24 volt battery that is rechargeable. Along with a charging unit, hand held
controller and control compartment. The 24 volt battery mounts into the
control compartment and the battery simply snaps in. The battery should
be charged for 5-8 hours prior to the 1st use. There is a red emergency
stop button on top of the control unit. Turn this clockwise to the right to
ensure it is in the unlocked position.

The unit is operated by the 4 button easy to use controls. The arrow
pointing down will lower the lift when depressed, the arrow that points up
will raise the unit when depressed and the bottom arrows will rotate the lift
from left to right. If you hear the low battery indicator tone “Do Not Use
the Lift”. Proceed to remove the battery from the unit and place battery on
the charging unit.

RECHARGING THE BATTERY:

Remove battery from the unit by unclipping from the control compartment.
Place the battery in the charging unit.

When the battery is placed on the charger the light will change to “Red” to
indicate it is charging. Once the light turns to “Green” the charger is
indicating that the battery is fully charged and is ready for use in your
Rotational Series pool lift.

Dec 2012 Page 5

ROTATIONAL SERIES POOL LIFT OPERATING

INSTRUCTIONS

Prior to using the Rotational Series Pool Lift, perform a test run of the lift empty. Once
that is completed and the lift is back to original position, make sure that the arm lifts
are in the up position and the seatbelt is unbuckled, once acknowledged you are ready!

Once you are in the seat, buckle the seatbelt (make sure it is snug) and lower the arm
rails. Before you attempt to operate the lift, make sure the pathway is clear from any
obstacles.

Once you have the 4 button easy controls in your hand, press the Left or Right arrow
that specifies which direction you want the lift to move in, once over the water press
the down arrow to lower the lift into the pool, keep in mind you don’t have to go to the
bottom of the cycle, you can stop the lift whenever you deem comfortable to exit the
lift. However when exiting the pool while on the lift, you should complete the cycle back
to the top to have a completely safe exit from the pool.

Once submerged into the pool, unbuckle the seatbelt and raise the armrest and slide off
of the seat. Once you are done with your pool activity, make sure the seat is lowered
sufficiently to allow you too easily slide back into the chair. Once you are seated, buckle
the seatbelt and make sure that it is snug, lower the armrest.

Next, to raise the lift chair out of the pool, make sure you press the button/arrow that
represents up on the control. Apply continuous pressure until the lift comes to a
complete stop at the end of the complete up cycle and then press the left or right arrow
to return to the pool deck. You now can unbuckle the seatbelt and raise the arm rest
and exit the unit.

Dec 2012 Page 6

Maintenance

Regular servicing will help prolong the life of your lift. Routine maintenance and cleaning is very

important. The following is a routine maintenance you should follow.

Daily

o Check and charge battery
o Test for normal operations
o Inspect your lift
o Clean and dry the lift and seat with clean water
o Cover lift after use

Weekly

o Overview Daily Checklist
o Wipe away any surface rust with household spray cleaner
o Clean tough stains with a Scotch brite pad and wipe clean
o Cycle the lift to keep all parts moving freely

Monthly

o Inspects all connections, frame, seat etc,
o Clean battery and controller connections
o Clean metallic surfaces with a wax cleaner

The maintenance provision of the ADA states that “a public accommodation shall maintain in operable

working condition those features of facilities and equipment that are required to be readily accessible

to and usable by persons with disabilities"

Dec 2012 Page 7

TROUBLESHOOTING GUIDE

Before any troubleshooting commences make sure the battery has a full charge!

(1) Does the lift raise or lower

NO

(a) Check the battery connection and reconnect
(b) Check hand controls, make sure they are connected properly
(c) Check for any lose wires on the control compartment
(d) Check the connection cable for damage
(e) Check to see that the lock on top of the control unit is turned clockwise

and in the unlocked position

(f) Check the battery with a volt meter to determine if the battery has at

least 24 volts.

(2) The batteries will not charge?

Yes

(a) Battery not inserted adequately, re-insert battery and check position
(b) Check the Display light – Is it red to indicate charging.
(c) Check the main cable for damage.
(d) Subsequent charging can be restarted by briefly disconnecting the main

supply or the battery.

Dec 2012 Page 8

Global Lift Corp Warranty Information

The Commercial, Proformance, and Rotational series lifts have a Lifetime Limited Warranty on
the metal components of the frame, not including the powder coating process. The Superior series
lift has a 5 year structural limited warranty. Global Lift Corp warrants to the original retail end user
only products manufactured by Global Lift Corp, when properly installed in accordance to the
assembly and installation instructions, and when the equipment is properly used and maintained, be

free from material defects and workmanship as stated below:

 Warranty starts from date of original purchase
 Metal structure (not including powder coat) – Lifetime Limited

(Commercial/Proformance/Rotational Series)

 Metal structure (not including powder coat) 5 year limited structural warranty (Superior

Series)

 Actuator and controls – 2 years from date of purchase then 2 years prorated
 Actuator and controls – 3 years 50% coverage (Customer is responsible for 50% of

replacement cost

 Actuator and controls – 4 years 30% coverage (Customer is responsible for 70% of

replacement cost

 Battery – 1 year from date of purchase

This warranty does not cover damages to ANY of our lifts due to accident, abuse, negligence,
misuse, damage by improper use of chemicals, fading, ice damage, fire, rust beyond structural
damage( does not cover cosmetic rust), exceeding the weight capacity for model purchased, failure
to install or to assemble the product in accordance with the installation and assembly instructions,
normal wear and tear from day to day use, not maintained properly, if unit is altered or repaired
without written approval of Global Lift Corp – All Warranties are Void.

Dec 2012 Page 9

To commence the warranty claim process of a Global Lift Corp product, in writing provide place of
purchase along with the product name and description, date of installation and a detailed description
of the defect, along with a photo of the entire product and claimed defect. Prior to a 30 day period
after receiving the written warranty claim by Global Lift Corp and barring any unforeseen delays the
claimant will be notified of Global Lift Corp’s decision regarding the claim.

If the request made by Global Lift Corp for the product to be returned to its factory or distributor of

choice for inspection and/or repair, purchaser will be liable for “Freight Prepaid”. Global Lift Corp at

its option will replace or repair the defective item and deliver the repaired product or replacement to
the buyer of the product, freight prepaid by the purchaser to the destination on file in regards to the
original order. Parts and Products returned for replacement to Global Lift Corp shall remain the
property of Global Lift Corp under this limited warranty.

A new warranty period shall not be established for any repaired or replaced products. Replaced or
repaired products will remain under warranty only for the remainder of the original warranty period
for the original product purchased. No person or organization is authorized to make any other
specific or implied warranties on behalf of Global Lift Corp.

THE WARRANTIES ARE IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED,
WHICH ARE HEREBY DISCLAIMED AND EXCLUDED, INCLUDING WITHOUT LIMITATION ANY
WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR USE.

IN NO EVENT SHALL GLOBAL LIFT CORP BE LIABLE FOR ANY INCIDENTAL,
CONSEQUENCIAL, INDIRECT, SPECIAL EXEMPLARY OR PUNITIVE DAMAGES OR LOST
PROFITS FROM ANY BREACH OF THIS LIMITED WARRANTY.THE SOLE AND EXCLUSIVE

REMEDY OF THIS WARRANTY IN REGARDS TO GLOBAL LIFT CORP’S PRODUCT SHALL BE
LIMITED TO REPLACEMENT OR REPAIR AT A GLOBAL LIFT CORP’S FACILITY OR A DULY
APPOINTED DISTRIBUTOR’S LOCATION OR AT A GLOBAL LIFT CORP’S DESIGNATED

LOCATION. IN NO EVENT SHALL GLOBAL LIFT CORP LIABILITY EXCEED THE ENTIRE
AMOUNT PAID TO GLOBAL LIFT CORP BY THE ORIGINAL PURCHASER IN REGARDS TO THE
DEFECTIVE OR FAILED PRODUCT.

NO REPRESENTATIVE OF GLOBAL LIFT CORP SUCH AS AGENTS, DISTRIBUTORS AND
DEALERS HAS THE AUTHORITY TO ALTER IN ANY FASHION THE TERMS OF THIS

WARRANTY AND GLOBAL LIFT CORP IS “NOT” RESPONSIBLE FOR REPRESENTATION,

UNDERTAKING OR WARRANTY MADE BY ANY OTHER PERSON BEYOND THE WARRANTIES
EXPRESSED SET FORTH IN THIS WARRANTY.

Dec 2012 Page 10

Warranty Procedure

Warranty Claims shall be submitted to Global Lift Corporation by the distributor which

originated the sale with Global Lift Corporation or directly to Global Lift Corporation.
All RGA (Return Goods Authorization) documents shall be requested by and issued

only to the distributor which originated the sale or directly to Global Lift Corporation.
Global Lift Corporation shall determine warranty coverage validation and replacement

parts or repair, which were directed to the distributor which originated the sale or that
are initiated directly with Global Lift Corporation.

Warranty claims received from end users by Global Lift Corporation shall be re-directed
to the distributor which originated the sale with Global Lift Corporation or processed
directly by Global Lift Corporation.

Dec 2012 Page 11

GLOBAL LIFT CORP
WARRANTY REGISTRATION
PURCHASED BY:

Company Name:
__________________________________Contact:____________________
City: ______________________________ State: ___________ Zip: ___________
Phone: (_____) ______________________________

DEALER:

Name: ____________________________Phone Number___________________
City: __________________________ State: _______________ Zip: ___________
Phone: (_____) ______________________________
Model: __________________________ Serial Number: ____________________
Color: _______________ Purchase Price: $ _______ Date Purchased: ___________
I have read and I accept the warranty terms.
Signature: ______________________________________ Date: ______________

This card must be completed and returned to Global Lift Corp within 30 days of purchase date to assure
coverage.

Please mail to: Global Lift Corp, 684 N Port Crescent Suite C, Bad Axe, MI 48413

Dec 2012 Page 12

ROTATIONAL SERIES R-375 LIFT

NEW CONSTRUCTION & SAW CUT SLEEVE ANCHORING SYSTEM

INSTALLATION MANUAL

November 2013

New Construction/Saw Cut Sleeve

Anchor R-375

Prior to installing, please make sure you have filled out a Deck
Configuration Form to make sure you have the correct lift that fits
Your application.