Global Industrial 708360YL User Manual
globalindustrial.ca
Assembly Instructions Instrucciones de Ensamblaje Directives d’assemblage
Customer Service
US: 1-800-645-2986
Servicio de atención al Cliente
US: 1-800-645-2986
Service à la clientèle
Canada: 888-645-2986
Safety Gate
Model 708360YL
Ref. Qty. Description
1 1
2 1
H1 2
H2 2
H3 4
CONTENTS
Safety Gate
Clapper Plate
M8 x 2.5" x 4.5" Square U-Bolt
M8 x 2.5" x 4.5" Round U-Bolt
M8 Lock Nut
Mounting the gate to a post:
1. Place u-bolts over the end of the post and through the
base of the gate.
Use the square bolt (H1) for square tube or angle iron.
Use the round bolt (H2) for round tube.
2. Firmly tighten nuts (H3) to secure gate to the post.
H1 For
square tube
H2 For
round tube
H3
1
1
2
Shown with square
tube hardware
080119
SAFETY GATE
Assembly Instructions
Mounting the gate to a wall:
1. Hold the gate against the wall in the desired location
and mark the location of the mounting holes.
2. Predrill the holes to connect the gate if needed
(based on material).
3. Mount the gate to the wall using appropriate hardware
for the wall material (hardware not included).
4. Disconnect the clapper plate (2) from the gate and
remount on the opposing wall using appropriate
hardware for the wall material.
2
WARNING
Clapper plate must be installed for
this gate to satisfy OSHA 1910.23
Adjusting the gate length:
1. Twist the plastic collars counter-clockwise to loosen.
2. Pull on the end of the gate until the desired length
is achieved.
3. Twist the plastic collars clockwise to tighten.
2
Loading...