Global Industrial 640803 User Manual

SAFETY DATA SHEET
GHS SDS F688F Page 1 of 6
FOAMING 62% ALCOHOL HAND SANITIZER
SECTION 1 – PRODUCT AND COMPANY IDENTIFICATION
Product Name
:
Instant Hand Sanitizer
Product Codes
:
640803
Recommended use
:
Hand sanitizer
Product dilution information
:
Product is sold ready to use.
Company
: GLOBAL INDUSTRIAL 2505 MILL CENTER PARKWAY BUFORD, GA 30518
Chemtrec Phone
: 1-800-424-9300
Issuing date
:
12/01/2015
SECTION 2 – HAZARD(S) IDENTIFICATION GHS Classification
Flammable liquids
: Category 3
Eye irritation
: Category 2B
GHS Label Element
Hazards pictograms
:
Signal Word
: Warning
Hazard Statements
:
Flammable liquid and vapor. Causes eye irritation.
Precautionary Statements
:
Prevention:
Keep away from heat/sparks/open flames/hot surfaces. No smoking. Keep container tightly closed
Response:
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do so. Continue rinsing. If eye irritation persists: Get medical advice/attention. In case of fire: Use dry sand, dry chemical or alcohol-resistant foam for extinction.
Storage:
Store in a well-ventilated place. Keep cool.
Disposal:
Dispose of contents/container to an approved waste disposal plant.
SECTION 3 – COMPOSITION / INFORMATION ON INGREDIENTS
Pure substance/mixture
: Mixture
Chemical Name
CAS-No.
Concentration (%)
SAFETY DATA SHEET
GHS SDS F688F Page 2 of 6
FOAMING 62% ALCOHOL HAND SANITIZER
ETHANOL
64-17-5
60 - 65
GLYCERIN
56-81-5
0 – 5
SECTION 4 – FIRST AID MEASURES
In case of eye contact
: Flush eyes under eyelids with plenty of cool water for at least 15 minutes. If irritation persists, seek medical/advice attention.
In case of skin contact
:
If irritation persists, wash with water.
If ingested
:
Contact a physician or Poison Control Center immediately. Do not induce vomiting never give anything by mouth to an unconscious person.
If inhaled
:
Get medical attention if symptoms occur.
Protection of first-aiders
:
No special precautions are necessary.
Notes to physicians
:
Treat symptomatically.
SECTION 5 FIRE-FIGHTING MEASURES
Suitable extinguishing media
: Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.
Unsuitable extinguishing media
:
High volume water jet.
Specific hazards during firefighting
:
Fire Hazard. Keep away from heat sources of ignition. Flash back possible over considerable distance. Beware of vapors accumulating to form explosive concentrations. Vapors can accumulate in low areas.
Hazardous combustions products
:
Carbon oxides
Special protective equipment for fire-fighters
:
Use personal protective equipment.
Specific extinguishing methods
:
Use water spray to cool unopened containers. Fire residues and contaminated fire extinguishing water must be disposed of in accordance with local regulations. In the event of fire and/or explosion, do not breathe fumes.
SECTION 6 ACCIDENTAL RELEASE MEASURES
Personal precautions
:
Remove all sources of ignition. Ensure clean-up is conducted by trained personnel only. Refer to protective measures listed in Section 7 and 8.
Environmental precautions
:
Do not allow contact with soil, surface or ground water.
Methods of cleaning up
:
Eliminate all ignition sources if safe to do so. Stop leak if safe to do so. Contain spillage, and then collect with non-combustible absorbent material (e.g., sand earth, diatomaceous earth, vermiculite) and place in container for disposal according to local, state, and federal regulations (See Section 13). Flush away traces with water. For large spills, dike spilled material or otherwise contain material to ensure runoff does not reach a waterway.
SECTION 7 HANDLING AND STORAGE
Handling
:
Avoid contact with eyes. Take necessary action to avoid static electricity discharge (which might cause ignition of organic vapors). Keep away from fire, sparks and heated surfaces. Wash hands thoroughly after handling. Use only with adequate ventilation.
Loading...
+ 4 hidden pages