Global Cache GC-RG1 Quick Start Manual

Quick Start Guide
Global Caché
GC-RG1
General IR Receiver
The IR receiver is plasma and fluorescent friendly providing proper GC-RG1 placement. Unwanted signals must not be allowed within the receiver's viewing angle. The IR sensor is set back in the GC-RG1 to shield it from both infrared and electromagnetic noise. Place the GC-RG1 to avoid direct line-of-sight aim at noise sources, such as plasma screens and fluorescent lights. Keep noise sources out of the GC-RG1's field-of-view for proper operation.
Field of View
The GC-RG1 employs a 3 meter (~10ft) cable with a 3.5mm jack for easy installation and connection to the GC-IRE or Xantech distribution block. The cable may be extended to several 100 meters providing th e total cable capacitance does not exceed 15,000pF. A typical CAT5 or audio cable is 60pF per meter permitting 250 meter (~ 800ft) cable run without signal amplification.
Specifications:
Use with the GC-IRE To digitizes IR signals.
Xantech compatible Yes
IR frequencies capture range 30 KHz to 80 KHz
Capture distance 8m - 12m (26' - 40') remote dependent
Case size HxWxL. 10mm x 21mm x 25mm (.40" x .82" x .95")
Cable type 3 meter shielded with 3.5 mm stereo jack
IR signal indicator Blue LED
Viewing angle (left, right) 30 degrees
Viewing angle (top, bottom ) 10 degrees
Power requirements 7V - 15V@3mA (no load)
Output impedance (short-circuit protected) 150 Ohms
Note: A power supply is not required when used with the GC-IRE.
Global Caché, Inc. 160 East California Street, PO Box 1659 Jacksonville, Oregon 97530 Phone (541) 899-4800 Fax (541) 899-4808 www.globalcache.com Support: support@globalcache.com /Sales: sales@globalcache.com
Copyright ©2007 Global Caché, Inc. All rights reserved.
PN: 122106-01 ver3/Information subject to change without notice.
Loading...