GLOBAL AMICI 3301630 User Manual
Versi
User’s Manual
Single Board Computer 3301630
on 1.0,
April 2005
Copyrights
This manual is
copyrighted and all rights are reserved. It does not allow any
non authorization in copied, photocopied, translated or reproduced to any
el
ectronic or machine readable form in whole or in part without prior written
consent from the manufacturer.
In general, the manufacturer will not be liable for any direct, indirect, special,
incidental or consequential damages arising from the use of inability to use
the product or documentation, even if advised of the possibility of such
damages. The manufacturer keeps the rights in the subject to change the
contents of this manual without prior notices in order to improve the function
design, performance, quality and reliability. The author assumes no
responsibility for any errors or omissions, which may appear in this manual,
nor does it make a commitment to update the information contained herein.
Trademarks
Intel is a registered trademark of Intel Corporation.
Award is a registered trademark of Award Software, Inc.
All other trademarks, products and or product's name mentioned herein are
mentioned for identification purposes only, and may be trademarks and/or
registered trademarks of their respective companies or owners.
3301630 User’s Manual
3
Packing List:
Please check the package content before you starting using the board.
Hardware:
3301630 motherboard x 1
Cable Kit:
44-pin
44-pin
SDTV Cable x 1
CPU Cooler x 1
40-pin
A T A 33 IDE Cable x1
SA TA Cable x 2
YPbPr Cable x 1 COM port Cable x 2
PS/2 Keybroad & Mouse cable x 1DVI-I Y cable x 1
Floppy Cable x 1
Parallel cable x 1
Dual USB cable with bracket x 1
Printed Matters:
User’s Manual x 1
Driver CD x 1
Audio cable with bracket x 1
3301630 User’s Manual
4
Index
Chapter 1 <Introduction> ............................................................................ 7
1.1 <Product Overview>.......................................................................... 7
1.2 <Product Specification>..................................................................... 8
1.3 <Mechanical Drawing>.................................................................... 10
1.4 <Block Diagram>..............................................................................11
Chapter 2 <Hardware Setup>.................................................................... 13
2.1 <Connector Location>...................................................................... 13
2.2 <Jumper Location & Reference>...................................................... 15
2.3 <Connector Reference>................................................................... 16
2.3.1 <Internal Connectors>............................................................ 16
2.3.2 <External Connectors>........................................................... 16
2.4 <CPU and Memory Setup>.............................................................. 17
2.4.1 <CPU Setup>......................................................................... 17
2.4.2 <Memory Setup>.................................................................... 18
2.5 <CMOS Setup>............................................................................... 19
2.6 <Enhanced IDE Interface>............................................................... 20
2.7 <Serial AT A Interface> ..................................................................... 20
2.8 <Floppy Port>.................................................................................. 21
2.9 <Ethernet Interface>........................................................................ 22
2.10 <Onboard Display Interface>......................................................... 23
2.10.1 <og Display>........................................................................ 23
2.10.2 <Digital Display>................................................................... 24
2.10.3 <HDTV Interface>................................................................. 28
2.1 1 <Integrated Audio Interface>.......................................................... 29
2.12 <GPIO Interface>........................................................................... 31
2.13 <Power Supply>............................................................................ 32
2.13.1 <Power Input>............................................................................ 32
2.14 <Switch and Indicator>.................................................................. 33
Chapter 3 <System Set up>........................................................................ 34
3301630 User’s Manual
5
3.1 <Video Memory Setup>................................................................... 34
Chapter 4 <BIOS Setup>............................................................................ 36
Appendix A <I/O Port Pin Assignment >.................................................... 38
A.1 <IDE Port>...................................................................................... 38
A.2 <Serial AT A Port> ............................................................................ 39
A.3 <Floppy Port>.................................................................................. 39
A.4 <IrDA Port>..................................................................................... 40
A.5 <Serial Port>................................................................................... 41
A.6 <VGA Port>..................................................................................... 42
A.7 <LAN Port>..................................................................................... 42
A.3 < USB Interface >............................................................................ 42
Appendix B <Flash BIOS>......................................................................... 43
B.1 <Flash Tool>.................................................................................... 43
B.2 <Flash BIOS Procedure>................................................................. 43
Contact Information................................................................................... 44
3301630 User’s Manual
6
(This Page is Left for Blank)
3301630 User’s Manual Introduction
7
Chapter 1 <Introduction>
1.1 <Product Overview>
3301630 is the new generati on of the Half-size PCI CPU card, with supporting last Intel
Pentium M processors for 533MHz front side bus, Intel 915GM and ICH6-M chipset,
integrated GMA900 graphics, DDR2 m emor y, REALTEK AC97 Audio, Serial ATA, mini
PCI and dual Gigabit LAN.
New Intel Pentium M Processor
The board supports last Intel Pentium M processors with 533MHz front side bus, 2MB L2
cache, to provide more powerful performance than before.
New features for Intel 915GM chipset
The board integrates Intel 915GM and ICH6-M chipset, to pr ovide new generation of the
mobile solution, supports Intel GMA900 graphics, DDR2 400/533 memory, built-in high
speed mass storage interface of serial ATA,
Multimedia solution
Based on Int el 915GM and ICH6-M chipset, the board provides two high performance
onboard graphics, 24-bit dual channel LVDS interface, HDTV to meet the very
requirement of the m ultimedia application.
Flexible Extension Interface
The board provides one CompactFlash Type II slot and one mini-PCI slot.
Product Overview
3301630 User’s Manual Introduction
1.2 <Product Specification>
General Specification
Form Factor Half-size PCI CPU card
CPU Intel® Pentium M (Does not support Celeron M 4xx seriesp rocessors)
Package type: FC-PGA478
L2 Cache: 512KB/1MB/2MB
Front side bus: 400/533MHz
Memory 2 x 240-pin DDR2 400/533MHz SDRAM up to 2GB
Up to 8GB/s of bandwidth with dual-channel interleaved mode
Dual-Channel technology supported
Unbufferred, none-ECC memory supported only
Chipset Intel® 915GM (Northbridge) and ICH6-M (Southbridge)
BIOS Phoenix-Award v6.00PG 4Mb PnP flash BIOS
Green Function Power saving mode includes doze, standby and suspend modes. ACPI
version 1.0 and APM version 1.2 compliant
Watchdog Timer System reset programmable watchdog timer with 1 ~ 255 sec./min. of
timeout value
Real Time Clock Intel® ICH6-M built-in RTC with lithium battery
Enhanced IDE UltraDMA33/66/100 IDE interface supports up to 2 ATAPI devices
One 44-pin IDE port onboard
One CompactFlash Type II socket on solder side
Serial ATA Intel® ICH6-M integrates 2 Serial ATA interfaces
Up to 150MB/s of transfer rate
Multi-I/O Port
Chipset Intel® ICH6-M with Winbond® W83627THF controller
Serial Port 3 internal RS-232 serial ports one internal RS-232/422/485 serial ports
USB Port Two Hi-Speed USB 2.0 ports with 480Mbps of transfer rate
Parallel Port One internal
Floppy Port One standard type Floppy port
IrDA Port One IrDA compliant Infrared interface supports SIR
K/B & Mouse External PS/2 keyboard and mouse ports on near LAN port
GPIO One 12-pin Digital I/O connector with 8-bit programmable I/O interface
Smart Fan One CPU fan connectors for fan speed controllable
VGA Display Interface
Chipset Intel® 915GM GMCH (Graphic Memory Controller Hub)
Frame Buffer Up to 128MB shared with system memory
Display Type CRT, LCD monitor with digital display
Onboard 24-bit dual channel LVDS interface
Onboard HDTV interface
Conne ctor External DVI female connector on near LAN port
Onboard 40-pin LVDS connector
Onboard 8-pin TV-out connector
Product Specification8
3301630 User’s Manual Introduction
9
ITX motherboard with onboard VGA, Dual Gigabit
LVDS, HDTV,
Ethernet Interface
Controller Marvell 88E8053 PCI Express Gigabit Ethernet controller
Type Triple speed 10/100/1000Base-T
auto-switching Fast Ethernet
Full duplex, IEEE802.3U compliant
Conne ctor Dual External RJ45 connectors with LED on rear I/O panel
Audio Interface
Chipset In tel® ICH6M with Realtek® ALC201A codec
Interfa ce 2 channels
Conne ctor Onbo ard Audio connector for Line-out, Line-in, MIC-in
Onboard CD-IN connector
Expansive In terface
CF One CompactFlash Type II socket on solder Side
PCI One Mini-PCI socket for TYPE III (32-bit, 33MHz)
Power supply: +3.3V, +5V
Power and Environment
Power
Requirement
Dimension 185mm (L) x 121 (H) mm
Temperature Operating within 0 ~ 60P
Onboard 4-pin connector
DC 5V/12V
Storage within -20 ~ 85P
o
P
C (32 ~ 140P
o
P
C (-4 ~ 185P
o
P
F)
o
P
F)
Ordering Code
3301630 Intel Pentium M Mini-
LAN, SATA, USB 2.0 Ports, Audio, 4 x RS232 serial port,
Mini-PCI
The specifications may be different as the actual production.
For further produ ct in forma tion pl ea se visit th e website at TUhttp://www.globalamericaninc.com
Product Specification
3301630 User’s Manual Introduction
10
1.3 <Mechanical Drawing>
Mechanical Drawing
3301630 User’s Manual Introduction
11
Intel Pentium M/Celeron M Processors
1.4 <Block Diagram>
Intel GMA900 Graphics
LVDS
2 x 240-pin DDR2
DVI
HDTV
SDVO
915GM
400/533MHz up to
2GB
CompactFlash
UltraDMA33/66/100 IDE
2 x USB2.0 ports
ALC201A
2 x Serial ports
2 x Serial ports
1 x Floppy ports
ICH6-M
BIOS
1 x Parallel Port
2 x Serial ATA ports
PCIE
PICMG
Marvell E8053
Gigabit LAN
Mini-PCI slot
8-bit GPIO
Block Diagram
IrDA
3301630 User’s M anual
12
(This Page is Left for Blank)
3301630 User’s Manual Hardware Setup
13
CN_LVDS2 JFRNT CN_PS
CN_USB COM12 COM34 CN_ LPT CN IR CN_DIO SYSFAN
PS2
CN_VGA
CN_AUDIO
CN_PWR
DVI
Chapter 2 <Hardware Setup>
2.1 <Connector Location>
IDE
JCSEL1
JCSEL2
RJ45_A
RJ45_B
Floppy
CN_ATKB JCFSEL SATA JVLCD2 CN_INV CN_TV CPUFAN
Connector Location
3301630 User’s M anual
14
CF
Loading...