GLG Pastello Series User Manual

GLG Lighting products 1

Pastello series RGBW 4 in one USER MANUAL

Every person involved with the installation, operation and maintenance of this device has to

- be qualified

- follow the instructions of this manual

- consider this manual to be part of the total product

- keep this manual for the entire service life of the product

- pass this manual on to every further owner or user of the product

- include every supplementary update with the original manual

Before your initial start-up, please make sure that there is no damage caused during shipment.

Should there be any, do not use the device and consult your supplier.

SAFETY INSTRUCTIONS

This device has left our premises in absolutely perfect condition. In order to maintain this

condition and to ensure a safe operation, it is absolutely necessary for the user to follow the safety

instructions and warning notes written in this user manual.

Important: Damages caused by the disregard of this user manual are not subject to warranty. The

dealer will not accept liability for any resulting defects or problems.

Always plug in the power unit least.

GLG Lighting products 2

Keep away from heaters and other heating sources! Keep away children and amateurs from the

device! Never leave the device running unattended!

If the device has been exposed to drastic temperature fluctuation (e. g. after transportation), do not

switch it on immediately. The arising condensation water might damage your device. Leave the

device switched off until it has reached room temperature.

Always disconnect from the mains, when the device is not in use or before cleaning it.

There are no serviceable parts inside the device. Maintenance and service operations are only to be

carried out by authorized dealers.

Please note that damages caused by manual modifications on the device or unauthorized operation

by unqualified persons are not subject to warranty.

OPERATING DETERMINATIONS

This device is an LED lighting for color decoration in discotheques, on stages etc. It is allowed to

be operated with an AC of 200 - 250 V, and is designed for indoor use only.

This device is NOT designed to use at full output on all Led colors for a long time such as used in

fairs. It is a show light which normally will be used in show lighting with continually variation of

output and colors. The device can handle two colors in full output for a long time. Also flashing

with all outputs to full for short time will be no problem.

Do not shake the device. Avoid brute force when installing or operating.

When choosing the installation-spot, please make sure that the device is not exposed to extreme

heat, moisture or dust. There should not be any cables lying around. You endanger your own and

the safety of others!

Operate the device only after having familiarized with its functions. Do not permit operation by

persons not qualified for operating the device. Most damages are the result of unprofessional

operation!

Please use the original packaging if the device is to be transported.

Please consider that unauthorized modifications on the device are forbidden due to safety reasons!

If this device will be operated in any way different to the one described in this manual, it may

suffer damages and the guarantee becomes void. Furthermore, any other operation may lead to

dangers like short-circuit, burns, electric shock, etc.

GLG Lighting products 3

REAR PANEL

CONTROL PANEL

1. LED DISPLAY

2. MENU BUTTON

3. ENTER BUTTON

4. UP BUTTON

5. DOWN BUTTON

GLG Lighting products 4

SETUP

1. Rigging the device

This device can be installed directly onto a truss, wall or stage floor in any orientation without

altering its operation characteristics.

Use proper bolts to mount the device via its brackets. The brackets should be attached to the

device with proper bolts!

Always use a secondary safety rope that can hold at least 10 times the weight of the device.

The minimum distance between the device and illuminated surface is 1 meter. There should not be

any flammable materials 10 meters around the device!

2. Connection to mains

Connect the device to mains with the enclosed power plug. The occupation of the connection

cables is as below:

The earth has to be connected.

3. Master-slave / DMX 512 connection