Please keep this handbook for future reference, or for
anyone else who may use the appliance.
1
Congratulations on your choice of a Belling quality Appliance which has been designed
to give you service for many years.
WARNING !
IMPORTANT !
DO NOT connect your appliance to the electricity supply until all packing and transit
protectors have been removed.
• Leave to stand for at least 4 hours before switching on to allow compressor oil to
settle if transported horizontally.
• If you are discarding an old refrigerator with a lock or latch fitted to the door , disable
the lock/latch, ensure that it is left in a safe condition to prevent the entrapment of
young children.
• This fridge/freezer must only be used for its intended purpose i.e the storing and
freezing of edible foodstuff.
• Do not dispose of the appliance on a fire. At Belling, the care and protection of our
environment is an ongoing commitment. This appliance which is among the latest
range introduced is particularly environment friendly. Your appliance contains non
CFC / HFC natural substances in the cooling system (Called R600a) and in the
insulation (Called cyclopentane) which are potentially flammable if exposed to fire.
Therefore, take care not to damage, the cooling circuit / pipes of the appliance in
transportation and in use. In case of a damage do not expose the appliance to fire,
potential ignition source and immediately ventilate the room where the appliance is
situated.
• We suggest you contact your local authority for disposal information and facilities
available.
• We do not recommend use of this appliance in an unheated, cold room.
(E.g.: garage, conservatory, annex, shed, out-house etc.)
• To obtain the best possible performance and trouble free operation from your
appliance it is very important to carefully read these instructions.
• Ensure that the plug remains readily accessible. Do not use multiple adapter bar.
• Failure to observe these instructions may invalidate your right to free service during
the guarantee period.
• Route electrical supply cord to allow easy connection and disconnection after
installation.
• We recommend a separate switch be employed to ensure easy switch on / off.
WARNING- Keep ventilation openings, in the appliance enclosure or in the built-in
structure,clear of obstruction.
WARNING- Do not use mechanical devices or other means to accelerate the defrosting
process, other than those recommended by the manufacturer.
WARNING- Do not damage the refrigerant circuit.
WARNING- Do not use electrical appliances inside the food storage compartments
of the appliance, unless they are of the type recommended by the manufacturer.
• We suggest you keep these instructions in a safe place for easy reference.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by
a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
2
ELECTRICAL REQUIREMENTS
FITTED WITH
BS 1362 13A FUSE ALWAYS
FIT BS 1362 REPLACEMENT
CARTRIDGE FUSE
GREEN
&
YELLOW
OR
GREEN
N
BLUE
OR
BLACK
L
BROWN
OR
RED
22mm.
6mm.
6mm.
6mm.
32mm.
12mm.
FUSE
CORD GRIP
Before you insert the plug into the wall socket make sure that the voltage and
the frequency shown in the rating plate inside the appliance corresponds to
your electricity supply . Rating label is on the left hand side of freezer inner liner.
We recommend that this appliance is connected to the mains supply via a
suitable switched and fused socket in a readily accessible position.
Should the mains lead of the appliance become damaged or should it need
replacing at any time, it must be replaced by a special purpose made mains
lead which can only be obtained from a Belling Authorised Service Agent.
WARNING! THIS APPLIANCE MUST BE EARTHED
If the fitted moulded plug is not suitable for your socket, then the plug should
be cut off and an appropriate plug fitted. Destroy the old plug which is cut off
as a plug with bared cord could cause a shock hazard if inserted into a socket
elsewhere in the house.
The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse
need to be replaced an ASTABEAB approved BS 1362 fuse of the same rating
must be used. Do not forget to refit the fuse cover. In the event of losing the
fuse cover the plug must not be used until a replacement fuse cover has been
fitted. Colour of the replacement fuse cover must be the same colour as that
visible on the pin face of the plug. Fuse covers are available from any good
electrical store.
IMPORTANT! FITTING A DIFFERENT PLUG
As the colours of the wires in themains lead of this appliance may
not correspond with the
colouredmarkings identifying the
terminals in your plug proceed as
follows: (See diagram).
1. Connect the green-yellow or
green (Earth) wire to the terminal
in the plug marked 'E' or with the
symbol
yellow or green.
2. Connect the blue (Neutral) wire
to the terminal in the plug
marked 'N' or coloured black.
3. Connect the brown (Live) wire
to the terminal in the plug marked
'L' or coloured red. With alternative
plugs a 13 A fuse must be fitted
either in the plug or adaptor or in
the main fuse box.If in doubt contact a qualified electrician.
or coloured green and
3
TRANSPORTATION INSTRUCTIONS
1. The appliance should be transported only in a vertical upright position. The
packing as supplied must be intact during transportation.
2. If during the course of transport the appliance has to be transported horizontally ,
it must only be laid on its left hand side when standing in the front of the
appliance. After bringing it to upright position,it must not be operated for at
least 4 hours to allow the system to settle.
3. Failure to comply with the above instructions could result in damage occuring
to the appliance. The manufacturer will not be held responsible if these
instructions are disregarded.
4. The appliance must be protected against rain, moisture and other atmospheric
influences.
5. When positioning your appliance take care not to damage your flooring,
kitchen furniture, related parts and doors, pipes, wall coverings etc. Do not
move the appliance by pulling by the door.
6. Empty any water in the drain tray before moving. See section ‘Defrosting’ and
‘Care & cleaning’ for further information.
7. Make sure that the defrost water pipe at the back of the product is fixed to the
plastic evaporating pan on the top of the compressor, to avoid defrost water
spillage on the floor.
IMPORTANT : Care must be taken while cleaning / carrying the appliance to
avoid touching the bottom of the condenser metal wires at the back of the
appliance as you might injure your fingers and hands.
Do not attempt to sit or stand on top of your appliance as it is not designed for
such use. You could injure yourself or damage the appliance.
IMPORTANT: Make sure that mains cable is not caught under the appliance
during and after carrying / moving the appliance, to avoid the mains cable
becoming cut or damaged."
Do not allow children to play with the appliance or tamper with the controls.
Belling declines to accept any liability should the instructions not be followed.
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
•Children should be supervised to ensure that they do not play with the appliance.
4
INSTALLATION INSTRUCTIONS
1. The space in the room where the appliance is installed must not be smaller
than 10 cubic metres.
2. See for detailed Installation Instructions including reversing door opening
direction.
3. Do not put your fridge freezer in a cold room where the temperature is likely
to go below +5 degrees C (41 degrees F) during night time and/or especially
in winter.
This fridge freezer has been designed to operate in ambient temperatures
between +5 and +32 degrees C (41 and 90 degrees F) Therefore if the
appliance is installed in an unheated/cold room (eg: conservatory/annex/
shed/garage etc) then the appliance will not operate causing the freezer
compartment to run warmer and as a result the storage time of frozen food
may be reduced.
4. Do not place the appliance near cookers, radiators or in direct sunlight as
this will cause your appliance to work harder. If installed next to a source of
heat or freezer, maintain the following minimum side clearances:
From Cookers 50 mm (2")
From Radiators 300 mm (12")
From Freezers 25 mm (1")
5. Refer to cleaning and care section to prepare your appliance for use.
A special receptacle is supplied to store the
6.
mains plug during transit.
The receptacle is fixed at the back of the
cabinet, on the side of the compressor.
(See diagram) Gently remove the plug from
the receptacle. Never pull the mains cord, you
may damage the appliance. In the case of
transportation,ensure you locate the plug in
the receptacle provided to avoid transit
damage.
5
GETTING TO KNOW YOUR COMBI FRIDGE / FREEZER
DAIRY
COMPARTMENT
THERMOSTAT KNOB
INTERIOR LIGHT
WINE RACK
CABINET SHELVES
DEFROST WATER
COLLECTION CHANNEL
SALAD
CRISPER
FAST FREEZE
COMPARTMENT
FROZEN FOOD
COMPARTMENTS
EGG TRA Y
DOOR
SHELF
BOTTLE
SHELF
6
SUGGESTED ARRANGEMENT OF FOOD IN THE FRIDGE/FREEZER
The following guidelines and recommendations are suggested to obtain the
best results and storage hygiene.
1. The fridge compartment is for the short term storage of fresh food and
drinks.
2. The freezer compartment is
storage of pre frozen food. The recommendation for storage as
stated on the food packaging should be observed at all times.
3. Cooked dishes must be stored in airtight covered containers.
4. Fresh wrapped produce can be placed on the shelf. Fresh fruit and vegetables
should be cleaned and stored in the crisper bins.
5. Bottles can be placed in the door section.
6. To store raw meat, wrap in polythene bags and place on the lowest shelf.
Do not allow to come into contact with cooked food to avoid contamination. For
safety, only store raw meat for two to three days.
7. Keep the food packed wrapped or covered. Allow hot food and beverages
to cool before placing them in the fridge. Do not store explosive substances.
High proof alcohol must be stored upright in sealed containers. Left over canned
food should not be stored in the can.
8. Fizzy drinks should not be frozen and products such as flavoured water
ices should not be consumed too cold.
9. Some fruit and vegetables suffer damage if kept at temperatures near 0°C.
The refore wrap pineapples, melons, cucumbers, tomatoes and similar produce
in polythene bags.
10. Place chilled cooked food and similar food near the rear of the fridge inner
liner where the cold wall is located.
1 1. Shelves, racks, crisper bins, drawers, flaps, bottle grippers are all removable.
12. Do not leave frozen food at room temperature to thaw; the best way to
defrost food is to put it in the fridge to thaw slowly. Make sure you avoid
defrosting food or food juices drip onto other food.
13. For hygiene reasons, always wrap food using a suitable packaging material
before storing in your appliance to avoid contact with the appliance surface.
1
2
1
1
3
4
5
6
6
6
rated and suitable for the freezing and
7
7
8
9
10
TEMPERATURE CONTROL AND ADJUSTMENT
Operating temperatures are controlled by the
thermostat knob (see diagram) located on the
ceiling of fridge compartment. Settings may be
made from 1 to 5, 5 being the coldest position.
When the appliance is switched on for the first
time, the thermostat should be adjusted so that
after 24 hours, the average fridge temperature
is no higher than +5°C (+41°F). We recommend
you set the thermostat half way between the 1 and 5 setting and monitor
to obtain the desired temperature i. e. towards 5 you will obtain a colder
fridge temperature and vice versa. Some sections of the fridge may be
cooler or warmer (such as the salad crisper and the top part of the cabinet)
which is quite normal.
The normal storage temperature of the freezer should be -18°C (0°F).
Lower temperatures may be obtained by adjusting thermostat knob towards
5 position.
We recommend that you check the temperature with an accurate
thermometer to ensure that the storage compartments are kept to the
desired temperature.
Remember you must take your reading very quickly since the thermometer
temperature will rise very rapidly after you remove it from the freezer.
Please remember each time the door is opened cold air escapes and the
internal temperature rises. Therefore never leave the door open and ensure
it is closed immediately after food is put in or removed.
In case of a temporary ice build up in the fridge compartment, reduce
the thermostat setting to 1, monitoring at the same time that the
fridge temperature is maximum +5 degrees C [41 degrees F]. Once
the ice build up disappears and the appliance starts auto defrosting
again as normal, then you may increase the thermostat setting, if
required.
8
Loading...
+ 21 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.