Glen GL 7011 User Manual

OIL FILLED HEATER

GL 7011

Identifying Your Oil Filled Heater

Using Your Oil Filled Heater

Remove the heater and all the accessories from the carton. The Oil lled heater is packed with the castor wheels
unattached. Attach the wheels before operating as explained below:

ASSEMBLY

• Place the heater body upside-down on a scratch-fee location,make sure it is stable and will not fall.

• Screw off the wing nuts from the u-shaped bolt provided. Attach the u-shaped bolt to the ange between rst and
second ns (near the front cover).

• To attach the castor mounting plate to the heater body, insert the threaded ends of the u bolt in the holes on the
castor mounting plate.

• Screw the wing nuts back to the u bolt and fasten the wing nut properly. Do not over tighten, this may damage the
heater ange.

• The rear ange must be mounted between the end two ns.

Caution: Do not operate without wheels attached. Operate the Oil Filled Heater only in up right position (wheels on
the bottom, controls on the top), any other position could create a hazardous situation.

USAGE

Place the heater on the oor at least 90cm away from the wall and any other objects such as furniture, curtains or
plants. (Make sure the power supply used corresponds to the one on the rating label). With the thermostat control
switch in the “O” position and the power setting switch in the “OFF” position; plug the heater into the mains power
supply.

Thermostat: The desired room temperature can be adjusted using the thermostat. Simply turn the thermostat knob
clockwise, to increase the heat, and anti-clockwise to decrease the temperature.

Power setting switch

Turbo switch

Oil filled fins

Turbo

Cord storage

Castors

Thermostat control

Handle