Glen GL 4026, GL 4026 Plus User Manual

®

MIXER
GRINDER

GL 4026 / 4026 PLUS

USER’S GUIDE

SPECIFICATIONS*

Voltage

Power

Rating

Motor

Material

Speed Control

Motor Speed (RPM)

Weight

Carton Dimensions
(mm) (w x d x h)

Capacity Liquidiser Jar

Grinder Jar

Chutney Jar

Blender Jar

:

:

:

:

230 V AC 50 Hz

600 W

30 minutes

Universal

(Basic Unit)

(Liquidiser Jar)

(Grinder Jar)

(Chutney Jar)

(Blender Jar)

(Fruit Filter)

:

:

:

:

:

:

A.B.S.

Stainless Steel

Stainless Steel

Stainless Steel

SAN

S.S. Mesh Moulded

PRODUCT NAME : MIXER GRINDER

MODEL NO.: GL 4026 / 4026 PLUS

SERIAL NO.:

BILL NO. & DATE:

NAME OF OWNER:

ADDRESS:

*Subject to change without prior notice.

Basic Unit, Blender Jar, Grinder Jar, Chutney Jar, Fruit Filter, Spatula, User’s Guide.
Basic Unit, Liquidiser Jar, Blender Jar, Grinder Jar, Chutney Jar, Fruit Filter, Spatula, User’s Guide.

4026 -

4026 PLUS -

This warranty is not valid if :

PACKING LIST

WARRANTY

This GLEN Mixer Grinder is fully warranted against any defect arising out of defective materials or faulty
workmanship for a period of one year from the date of purchase. The motor is fully warranted against any
manufacturing defect for a period of five years from the date of manufacturing (inscribed on the motor).
Should any defect develop in this product, the customer should bring the product to the nearest authorised
service centre, where the company undertakes to get the product repaired free of charge.

Under no circumstances, whether based on limited warranty or otherwise shall the company be liable for
incidental, special or consequential damages. Use of product indicates acceptance by you of the aforesaid
terms and conditions.

The use and care instructions have not been followed.
Defects are caused by accident, misuse, abuse or commercial use.
The repair work is carried out by persons not authorised by the company.
Any modification or alteration of any nature is made in the product.
Normal wear & tear of the product is not covered under warranty
The Bill/Cash memo and copy of warranty card is not presented.

DEALER’S STAMP & SIGNATURE

Glen Appliances Pvt. Ltd.

EPIP Phase II, Thana Baddi, Tehsil Nalagarh, Distt. Solan (H.P.)

Head Office

I-34, DLF Industrial Area Phase-I, Faridabad - 121 003

Helpline : 0129-2254191 Fax : [phone]

E-mail : [e-mail] Website : www.glenindia.com

PULSE
OFF
1-Low, 2-Medium, 3-High

:

18000, (approx)- No Load.

5.20 kgs approx (4026)

6.00 kgs approx (4026 Plus)

490 X 235 X 295 (4026)

490 X 235 X 320 (4026 Plus)

1.5 Ltrs. 1.0 Ltr.

1.0 Ltr. 0.5 Ltr Dry

0.3 Ltr. Wet

0.4 Ltrs. 0.2 Ltr.

1.5 Ltrs. 1.0 Ltr.

Total Max. Working

®

While grinding always ensure that the blades are

covered by the substance to be ground.

Give a break of atleast one minute after continuous

grinding of 3 minutes.

Fill the Grinder Jar only upto ¼th of its capacity
and add required amount of water or milk so that
the blades don’t get jammed.

Fill the Liquidiser Jar only ¾th of its capacity to
avoid spilling of liquid, when you start the machine.
Do not allow children to handle the MG.
Keep the machine away from direct heat and
sunlight, at a suitable height on a flat surface for
easy operation.
Do not use the MG for ice crushing or grinding
raw meat.
Before running the machine ensure that the jars
and lids are firmly placed and locked. Do not
remove or replace jars when the motor is on.
While operating run the machine in short cycles
of 30-90 seconds as per requirement, do not run
it for a long duration.
Wide voltage fluctuations during operation may
affect the quality of grinding, the motor may still
be safe. It is safer to use a MG only when you get
steadier voltage in your area.
While dry grinding the jar may get heated up due
to friction. Don’t worry it has nothing to do with
motor.
Do not run the MG empty.
Do not overload the machine.
In case of smoke or smell putt off the machine.

STEPS TO SAFETY

OVER LOAD PROTECTION

To protect the motor from burning, in
case of overload, the appliance is fitted
with an automatic overload protector
under the base of the basic unit. If the
motor stops it is an indication of excess
load. Switch off the unit, take out excess material
from the jars. Wait for 2/3 minutes and press the
overload protection plunger. Then restart the unit.

Note: Overload protection plunger is to be pressed
to restart only after 2/3 minutes.

Dals, soups, juices, pastes (onion, ginger, garlic,
leafy, vegetables).

IDENTIFY YOUR MIXER GRINDER GL 4026 / 4026 PLUS

USING THE LIQUIDISER JAR / GRINDER JAR /
CHUTNEY JAR

TO CLEAN THE JAR

Fix the jar on to the basic
un it, by al igni ng the
marking of jar and main unit
and rotate clockwise to lock
the jar into position.

Fill the ingredients, close
the jar lid and hold with
hand. Operate the machine
with the knob at the desired
speed.
(The Pulse switch can be
used for additional froth in
Lassi or Cold Coffee using
the Liqudiser Jar / Blender jar).

Pour a little liquid soap and
water into the jar, close the
lid and run it on position 1
for a few seconds.
Pour out the soap solution
and rinse with tap water.

Remove the blade assembly
using spatula handle. Wipe
the area along the blade with
a wet cloth and then dry.

FUNCTIONS

Dry Grinding

Mincing / Grating

Wet Grinding / Liquidising / Pureeing / Blending

After grinding, remove the contents and wipe the jar
with a dry cloth. For the Chutney Jar follow the
instructions for the Liquidiser Jar except that the
blade is fixed.

Spices, coffee beans, rice, sugar, turmeric, wheat etc.

The Glen fruit filter is used for juicing soft seeded
fruits like water melon, grapes etc. It can also be used
to make tomato purees. Coconut milk coconut can
also be extracted using the fruit filter. Blender jar
without fruit filter is used for blending / liquidising
applications.

FRUIT FILTER

USING THE FRUIT FILTER

Insert the fruit filter into the
blender jar and rotate it
slightly so that it settles
down and the grooves get
locked with the slugs on the
blender jar wall.

Place the lid on the jar
(Drainage windows of lid
towards j ar spout) and
rotate it anti-clockwise to
lock.

Place the assembly onto the
drive shaft of the mixer
g ri nd er a n d r ot a t e
clockwise to lock it into
position.

Cut small pieces of fruits
(like watermelon, tomato
etc. to be juiced. Remove
the cap on the lid by rotating
anticlockwise. Put the cut
pieces into the filter and
switch on the mixer grinder.
You can continue adding more fruit pieces from the
centre opening in the lid as they are juiced. The juice
is sieved out through the filter and the pulp/seeds get
accumulated inside the filter.

Coconuts, carrots, radishes, onions, cabbages, dry
fruits, meat etc.

®

Main Unit

Spatula

FEW TIPS

TO CLEAN THE JAR / FILTER

For Thick Pastes: Fill the grinder jar only up to ¼th of

its capacity and add required amount of water so that
the blades don’t get jammed. For small quantities use
the Chutney Jar.

For Blending Liquids: Fill the liquidiser jar only up to

¾th of its capacity to avoid spillage.

Once the juicing is over,
replace the cap. Remove the
jar assembly from the drive
shaft and pour out the
contents from the jar by
tilting. Do not open the lid till
all the contents of the jar are
removed.

Pour a little soap and water
into the jar, close the lid and
run it on position 1 for few
seconds.
Pour out the soap solution
and rinse with tap water.
Altern atively us e a soft
brush to clean the filter
under running tap water.

Grinder Jar (S.S.)

(Dry & Wet)

Chutney Jar (S.S.)

Liquidiser Jar (S.S.)

(Only with 4026 Plus)

Blender Jar

Fruit Filter