Glastender WMR24S-R User Manual
Operation Manual & Parts List
A Family Company Manufacturing In The USA Since 1969
Lettuce crisper - Lc
countertop Merchandiser - cM24
WaLL-Mount refrigerator - WMr24s-L, WMr24s-r,
WMr24X-L, WMr24X-r
Manufacture date & seriaL nuMber inforMation
This manual is specic to:
• Lettuce Crispers:
and up to and including SN 134171318X, and PRIOR TO March 15, 2017.
• Countertop Merchandisers: manufactured September 22, 2011 and after starting with
SN 134136045 and up to and including SN 134171318X, and PRIOR TO March 15, 2017.
• Wall-Mount Refrigerators: manufactured September 22, 2011 and after starting with
SN 134133503 and up to and including SN 134171318X, and PRIOR TO March 15, 2017.
manufactured September 23, 2011 and after starting with SN 134133546X
CM24XX-RR
LC
Glastender, Inc. · 5400 North Michigan Road · Saginaw, MI · 48604-9780
800.748.0423 · 989.752.4275 · Fax 989.752.4444 · www.glastender.com
Rev. 02-27-19
WMR24S-R
© 2016 Glastender, Inc.
indeX
Topic Page
Utility Requirements and Connections ..................................................................... 1
Uncrating and Start-up Instructions .......................................................................... 1
Wall Mounting Instructions - LC and WMR ............................................................ 2
Cleaning Instructions ................................................................................................ 2
Digital Controller Operation ..................................................................................... 3
Electrical and Refrigeration Specifications .............................................................. 4
Electrical Diagram .................................................................................................... 4
Replacement Parts ..................................................................................................5-6
Electrical Components .............................................................................................. 6
Condenser and Related Parts ................................................................................. 7-8
Terms and Conditions .............................................................................................. 9
Warranty .................................................................................................................. 10
IMPORTANT !! Attention Service Companies IMPORTANT !!
Please review the important warranty information on page 10. If you believe a service call should be covered
by the factory, please call the factory for authorization between 8AM and 5PM EST, Monday through Friday.
introduction
This manual describes the operation features of the Lettuce Crisper, Countertop Merchandiser, and WallMount Refrigerator. Please review this information before attempting installation and operation. Long term,
trouble-free operation will follow if good housekeeping and maintenance procedures are followed. Thank you
for selecting Glastender, Inc. products.
.
utiLity requireMents and connections
Electrical: 115 Volt AC, 1 Phase, 60 Hz, 6.64 full load amps. A separate 15 amp circuit is
required. A 10-foot grounded cord is included.
Plumbing: Automatic condensate evaporator. No drain connection required.
uncrating and start-up instructions
All models are shipped in one carton. These steps should be followed:
1. If legs are included, bolt them to the base with bolts provided.
2. For lettuce crisper and wall-mount refrigerator wall mounting instructions, see page 3.
3. Position unit. It must be level and plumb.
4. Plug into 115 volt AC outlet.
5. Your Glastender equipment is now ready for use.
Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
1
800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com
C
WALL MOUNT BRACKET
BOTT
MOUNT
OF HOLES
L
OM BRACKET
STUDS IN WALL
24 ¾"
Lc & WMr WaLL Mounting instructions
INSTRUCTIONS:
NOTE: Mounting instruction applies to both the lettuce crisper and
wall-mount refrigerator. Lettuce crisper shown in illustration.
NOTE: 8″ of air space is required above unit to allow for air
flow out. WARNING: Compressor failure due to restriction or
blockage of air flow will void warranty.
16"
C
L
16"
C
L
BOTTOM OF LETTUCE CRISPER
1. Mark a level line at the bottom of the lettuce crisper / wall-mount
refrigerator.
2. From this line measure up 24¾″ and mark another level line.
3. On this line drill holes to match the holes in the wall mount
bracket.
4. Install wall mount bracket.
5. Attach lettuce crisper / wall-mount refrigerator.
6. If lettuce crisper / wall-mount refrigerator is not on an existing
shelf, secure with bottom bracket.
NOTE: At least two (2) of the mounting holes in the bracket should
line up with studs in the wall for safe, secure mounting.
MUST BE INSTALLED
HORIZONTALLY LEVEL
WALL
BRACKET
BOTTOM
BRACKET
MUST BE INSTALLED
VERTICALLY PLUMB
cLeaning instructions
ESTIMATED CLEANING TIME: 5 to 10 minutes per unit daily, 20 minutes weekly.
FREQUENCY: Daily cleaning of exterior & door gaskets. Weekly cleaning of interior.
PROCEDURE:
1. A non-chlorine based cleaner or mild detergent and warm water applied with a soft cloth or sponge to all contact surfaces.
2. Immediately rinse off cleaning agent(s), using clean warm water, clean soft cloth or sponge.
3. Dry with a soft clean cloth, removing standing water as soon as possible.
4. A more thorough cleaning of the interior should be done weekly (more frequently as necessary).
5. The condensing unit air filter (front top left) should be removed and thoroughly rinsed in hot clean water at least once per quarter.
NOTES:
1. Never use hydrochloric acid, wire brushes, steel wool, scrapers, or chlorine based cleaners on stainless steel surfaces, since they will
break down the passivity layer and allow corrosion to occur.
2. On stainless steel surfaces, you may use a soft bristle brush or Scotch-Brite® pad for more stubborn stains. Always scrub with the
direction of the grain. Follow with a thorough cleaning as described above.
3. Deposits from food preparation must be properly removed. Even hard water deposits will rust stainless steel, if not removed.
4. Door gaskets are most often overlooked when cleaning. Failure to clean them regularly will lead to premature failure, since alcohol
and moisture build-up breaks down the gasket material.
Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com
2
digitaL controLLer operation
The operating temperature range is preset at the
factory according to the table below and can be
adjusted up or down within the limits shown.
To change the set point - push and hold the SET
button for more than two seconds. When the º F
display begins ashing, push the up arrow or down
arrow buttons to adjust the set point to the desired
To see the set point - push and immediately release
value.
the SET button. The set point will be displayed.
To save the new set point and return to the
To return to normal visualization - Push and
immediately release the SET button or wait ve
temperature display mode - push and release the
SET button or wait ten seconds.
seconds.
Factory Settings Range of Adjustment
Set Point Operating Range† Minimum Set Point Maximum Set Point
LC, CM, WMR - Standard Cooler Setting
CM, WMR - White Wine Cooler Setting
CM, WMR - Red Wine Cooler Setting
† Adjusting the factory set point will also adjust the operating range by the same amount
34º F 34º F to 39º F 33º F 65º F
50º F 50º F to 55º F 33º F 65º F
60º F 60º F to 65º F 33º F 65º F
The lettuce crisper, countertop merchandiser,
and wall-mount refrigerator are programmed
to automatically defrost four times daily for
approximately twenty minutes. During defrost,
the fan inside the cooler will remain on and the
refrigeration system will turn off. To initiate defrost
manually, push and hold the DEFROST button for
more than two seconds.
The thermostat controller does not have an “OFF”
function. To turn the unit off, the unit must be
unplugged or power to the electrical branch circuit
has to be turned off via a circuit breaker or switch.
Models LC, CM24, and WMR24 regarding the
Dixell digital thermostat controller
The thermostat control probe wire connector may
become disconnected when the front cover is removed.
This will result in thermostat P1 code. While the P1
code is ashing the compressor will cycle 5 minutes
on and 5 minutes off and may cause icing of the
evaporator coil. Service calls to reconnect the probe
wiring are not covered by factory warranty.
Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
3
800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com
Probe wire
connector
Loading...