Glastender UCR24X-L, UCR24X-R Operation Manual

Operation Manual, Parts Directory and Price List

UndercoUnter refrigerator

UCR24X-L, UCR24X-R, UCR24S-L, & UCR24S-R

IMPORTANT!!

Attention Refrigeration Service Companies

Please review the important warranty information on page 4. If you believe a

service call should be covered by the factory, please call the factory for authorization

between 8AM and 5PM EST, Monday through Friday.

Glastender, Inc. · North Michigan Road · Saginaw, MI · 48604-9780

800.748.0423 · 989.752.4275 · Fax [phone] · www.glastender.com

Rev. 06-01-10

UCR24S-LUCR24X-L

© 2010 Glastender, Inc.

Ucr24 UndercoUnter refrigerator

STARTER

operation

The operating temperature range is 36°F (2°C) to 40°F (5°C).
UCR24S models include an automatic defrost system. The refrigerator will defrost every six hours for approximately 20 minutes. During the defrost,
the fan inside the cooler will remain on and the refrigeration system will turn off.

technical information

• Electrical: 120 Volt AC, 1 Phase, 60 Hz. 4.7 full load Amps, 1/4HP A separate 15 Amp circuit is recommended. A 6-foot grounded cord
and plug is included with self-contained models.

• Plumbing:

• Refrigerant:

cleaning instrUctions

Cleaning is essential to sustaining the integrity of your equipment and preventing corrosion.

ESTIMATED CLEANING TIME: 5 to 10 minutes per unit daily, 45 minutes quarterly
FREQUENCY: Daily cleaning of exterior & door gaskets. Quarterly cleaning of interior, including shelves.
PROCEDURE:

1. A non-chlorine based cleaner or mild detergent and warm water applied with a soft cloth or sponge to all contact surfaces.

2. Immediately rinse off cleaning agent(s), using clean warm water, clean soft cloth or sponge.

3. Dry with a soft clean cloth, removing standing water as soon as possible.

nOTES:

1. Never use hydrochloric acid, wire brushes, steel wool, scrapers, or chlorine based cleaners on stainless steel surfaces, since they will break down

the passivity layer and allow corrosion to occur.

2. On stainless steel surfaces, you may use a soft bristle brush or Scotch-Brite® pad for more stubborn stains. Always scrub with the direction of

the grain. Follow with a thorough cleaning as described above.

3. Deposits from food preparation must be properly removed. Even hard water deposits will rust stainless steel, if not removed.

4. The cooler door gaskets are most often overlooked when cleaning. Failure to clean them regularly will lead to premature failure, since alcohol

and moisture build-up breaks down the gasket material.

Automatic condensate evaporator is included. No drain connection required.

10.0 oz, R134a, Operating pressure high is 186 PSIG, low is 88 PSIG.

sealing refrigerator to floor

To comply with NSF & health codes, the refrigerator
base must be sealed to the floor using NSF listed sealant.
Place a bead of sealant along outer edges of the base and
remove excess with disposable towel. The floor sealing
procedure does not apply to models that include legs or
casters.

16ga Wire

MAIN

POWER

SUPPLY

CORD

115v AC

5.5amp

Wiring diagram

Ucr24 m

odels

60hz

BALLAST

BLACK

BLACK

WHITE

GREEN

CONDENSER FAN

BLACK

COM

RUN

LIGHT SWITCH

BLACK

OVERLOAD

START

RED

BLACK

WHITE

RELAY

STARTER

BLUE

S

LIGHT

EVAPORATOR FAN

BLUE

YELLOW

WHITE

WHITE

WHITE

ORANGE

DEFROST TIMER

4 32 1

BLUE

ORANGE

THERMOSTAT

COMPRESSOR

ALL WIRE TO BE 16 GA.

Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780

2

800.748.0423 • 989.752.4275 • Fax [phone] • www.glastender.com