Glastender BB, ND, PT, LP General Manual

Project:

Item #: Qty:

AIA#

SIS#

Model #:

Laminated Compressor

Compartment Details

Top

Center

Bottom

Figure 1 Figure 2

Foam Tape

Bottom Flange

Air Diverter

Glastender Back Bar, Narrow Door, Low Profile, and Pass
Thru Coolers can be supplied with unlaminated compressor
compartment covers.

Unlaminated compressor compartment covers consist of a
galvaneal cover on to which the laminate is glued in the field.
Special black vinyl-clad trim rails are supplied by the factory to
attach to the outer edge of the cover on all four sides to protect
the laminate edge.

The field lamination instructions are illustrated in the photo­graphs on the bottom left. The dimensional specifications for
the laminate pieces required are as follows:

Models Top CenTer BoTToM

BB, ND, & PT 11-15/32″ x 10-3/4″ 11-15/32″ x 1-5/8″ 11-15/32″ x 3-7/8″

LP 11-9/16″ x 2″ 11-9/16″ x 4-1/2″ 11-9/16″ x 3-3/4″

Note: These dimensions are slightly oversized, so

trimming is likely required.

Compressor Compartment Cover Field
Lamination Instructions

1. Begin by cutting the three pieces of laminate required (see
dimensional chart above) making sure to orient any grain
pattern in the correct direction.

2. Make sure the compressor cover is free from oil and debris.
Apply adhesive to both the back of the laminate and the face
of the cover. Carefully position the laminate and apply to
cover. This should immediately be rolled out to remove any
air bubbles. Repeat this procedure for the other two sections.

3. To install the trim rails, position each rail, one at a time, and

drill out the required holes with a 9/64″ drill bit. Fasten each

rail into place with the black pop rivets provided. Figure 1
shows the relative position of each piece in the assembly.

4. Finally, install 1/4″ x 1/2″ foam tape along both sides and
across the air diverter. See Figure 2.

5. Install the plastic grilles by simply snapping them into place.
Install a foam filter over the bottom grill and secure with
elastic bands in a criss-cross pattern as shown in Figure 2.

6. To install the compressor compartment cover on BB, ND,
and PT models, secure with a screw through the top of the
compartment cover. On LP model, position the top flange of
the cover under the top lip of the compressor compartment.
Finally, on all models, secure the cover into place with two
screws through the bottom flange.

the

Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780

989.752.4275 • 800.748.0423 • Fax [phone]
www.glastender.com

Specications subject to change without notice. For current specications please visit our website.

Printed in USA

4.28

Approval/Notes:

Rev. 04-22-08