Glastender MFV User Manual
Project:
RAISED/DECOR
WOOD MUST
MAINTAIN 3"
DOOR FRAME
(TO ENSURE
PROPER MOUNTING
OF DOOR HANDLE)
3/4"
HEIGHT
WOOD PANEL
DOOR
WIDTH
3"
WOOD
PANEL
DOOR
BLACK
VINYL-CLAD
DOOR
Item #: Qty:
AIA#
SIS#
Model #:
Wood Panel Cooler
Door Details
Glastender Back Bar, Narrow Door, Low Profile, Pass Thru,
Rear Feed, and Front Venting coolers, Front Venting Mug
Chillers, and Dry Storage cabinets can be supplied with hinge
hardware to accommodate 3/4″ thick wood panel doors attached
to the front of the standard black vinyl-clad doors.
The specification when ordering must call out for hinge hardware to accommodate wood panel doors. The cooler top must
be at least 26″ deep. See also, the wood compressor compartment cover details shown on page 4.31 of this specification
guide.
The dimensional details for fabrication of the wood panels doors
are illustrated in the detail to the left with the width and height
dimensions listed below:
SerieS Width height
BB, PT, RF, DS ....... 23-5/8″ ...........33-3/8″
ND ........................... 19-5/8″ ...........33-3/8″
LP, FV ..................... 23-5/8″ ...........27-1/2″
MFV ........................ 23-5/8″ ...........24-3/4″
Printed in USA
NOTE: Raised panel wood doors do not meet UL ammability
test requirements. Coolers manufactured with raised panel wood
doors do NOT carry the UL mark. Please verify acceptability
with your local electrical inspector prior to ordering.
Wood Panel Door Mounting Instructions
Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
Specications subject to change without notice. For current specications please visit our website.
989.752.4275 • 800.748.0423 • Fax 989.752.4444
www.glastender.com
4.29
1. Remove the black vinyl-clad door from the cooler by removing the
screws from the top hinge. The door can then tilt out from under
the hinge and be lifted up off the bottom hinge bracket.
2. Secure the top hinge back in place.
3. Lay the black vinyl-clad door down and position the wood panel
on top of it. No sealant or glue is required between the black vinylclad door and the wood panel.
4. Align the wood panel accordingly, then pre-drill starter holes in
the wood panel through the upper and lower wood panel mounting
plates already attached to the black vinyl-clad door. The top and
bottom hinge also function as wood panel mounting plates.
5. Mount the wood panel with screws through all of the wood panel
mounting plates except the top hinge. The handle must be mounted
at this time as well.
6. Remove the top hinge from the black vinyl-clad door and set the
bottom hinge pin into the bottom hinge bracket. Be sure to use the
plastic spacer washers provided for the upper and lower hinge pins.
7. Place the top hinge on the top hinge bracket pin and then position
the door beneath the hinge to align with mounting holes.
8. Fasten the top hinge to the black vinyl-clad door and the wood
panel and the installation is complete.
Approval/Notes:
Rev. 10-27-08
Loading...