GT-24-CW
Project:
Item #: Qty:
AIA#
SIS#
Model #:
24" Rotary
Glasswasher
GT-24-CW-208, GT-24-CW-240,
GT-24-CCW-208, GT-24-CCW-240
Standard Features
• Removable top and front shield for easy cleaning access
• Available with clockwise or counterclockwise rotation.
• Conveyor lifts out for easy cleaning.
• Set of three separate curtains is included
• Switch panel may be relocated in the field
• Removable side panels for easy service access
• Spray boxes unlatch for easy cleaning - engineered for maximum soil removal
• 4000 watt heater encased in an incoloy sheath to resist caustic
detergents
• Digital temperature gauges built into switch panel
• Thermostat controls wash tank temperature
• Automatic electronic peristaltic metering pumps
• 1/6 HP pumps recirculate wash water and rinse water
• Fractional HP drive motor powers the belt driven conveyor and
includes built-in slip clutch
• Sensor activated low water cutoff in wash tank protects heater
• Automatic chemical sensor alerts operator when detergent and
sanitizer is low
• Prime switches provided for high speed chemical priming
Specications
General Plumbing [Hot water and cold water required]
• Plumb with 1/2" water supply. Adapt to 3/8" FMPT.
• Minimum water pressure is 25 PSI
• Maximum water pressure is 100 PSI. Install water pressure reg ulator if line pressure is over 100 PSI. Water valve on unit has
built-in strainer and flow control to provide consistent volume
between 25 and 100 PSI
• Install separate water shut-off valve for each connection
• Unit has built-in air gaps. Vacuum breakers are not required
Hot Water Only
• Maximum temperature is 150ºF (66ºC), minimum is 130ºF
(54ºC).
• Initial fill is 3 gallons. Maximum consumption is 1/4 gallon per
minute during operation
Cold Water Only
• Minimum temperature is 75ºF (24ºC) per FDA Code. Install
hot/cold mixing valve if necessary.
• Initial fill is 2-1/4 gallons, maximum consumption is 2 gallons
per minute during operation
Drain
• 1-1/2" tailpiece.
• Use open type floor drain for maximum drainage
• Two white plastic drain cocks extending below the bottom are
for recirculating pump drainage when required for replacement
or winterizing. The drain cocks are in the closed position - no
plumbing is required.
Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
989.752.4275 • 800.748.0423 • Fax 989.752.4444
www.glastender.com
Specications subject to change without notice. For current specications please visit our website.
Printed in USA
1.01
Electrical
• 120/208-240V, single phase, 60Hz, 3-wire (two hot and one
neutral), ground connected per local code (green wire), 20 amp
for 240 volt or 30 amp for 208 volt (4 wire total), unit will oper-
ate within 10% of rated voltage
• Dedicated 20 amp circuit required [30 amp for 208V]
• A power relay in the unit separates the high and low voltages
and directs the respective power to the electrical components.
The heater and power light operate on 208 or 240 volts - all
other components operate on 120 volts.
Detergent
• Extra heavy duty, non-foaming, commercial liquid dishwashing
detergent is required - .30% concentration
• Consult local chemical supplier to match detergent with local
water conditions
Sanitizer
• Liquid chlorine bleach (sodium hypochlorite - 5.25% solution)
adjusted to 50 ppm or iodophor adjusted to 12.5 ppm
Capacity
• 3 minute cycle, 60 second wash and 60 second rinse exposure
• 13 glasses† per minute or 800 per hour (maximum glass
height 11" - including pitchers and wine carafes)
Materials
• 20 and 22 gauge stainless steel parts include: cabinet
• 18 gauge stainless steel parts include: floor and tanks
• 16 gauge stainless steel parts include: leg mounting brackets
and legs
• Conveyor is electropolished, welded stainless steel wire
† Based on 2-3/4″ diameter bar glasses
Approval/Notes:
Rev.10-31-07
GT-24 Glasswasher
UNLOAD LOAD LOAD UNLOAD
ROTATIONROTATION
R R
COUNTERCLOCKWISE (CCW) ROTATION
2
3
4
1
2
4
3
A
B
1 = HOT WATER
2 = COLD WATER
3 = DRAIN
4 = ELECTRICAL
A - LEFT SIDE (FOR CCW COCKTAIL STATION)
B - FRONT (UNDERBAR-CCW ROTATION)
C - FRONT (UNDERBAR-CW ROTATION)
D - RIGHT SIDE (FOR CW COCKTAIL STATION)
POSSIBLE SWITCH PANEL LOCATIONS
D
C
CLOCKWISE (CW) ROTATION
FRONT ELEVATION VIEW
FRONTFRONT
FRONT FRONT
POSSIBLE SWITCH PANEL LOCATIONS
1
CCW CW
ADJUSTABLE FROM 38-1/2" TO 39-1/2"
DRAIN
DRAIN
electrical, and health codes for
the floor at the bottom of
to change without notice.
3. The Glastender policy of constant quality
improvment means specifications are subject
the unit approximately 7" to 8" high
2. The utility connections are made from
with the information on the front of this
regulations which may not be consistent
1. In all cases, consult local plumbing,
specification sheet
4. Detergent and sanitizer containers are stored
externally. Six-foot lenghts of tubing are provided.
Storage for two one-gallon containers is required
within five feet.
5. Front side service is essential.
38-1/2"
36-1/2"
29-1/2"
7"
3-3/4"
5-3/4"
1-1/4"
16"
12-1/16"
12-1/16"
2"
24-1/8"
16"
16"
8-1/8"
24-1/8"
24-1/8"
1" MINIMUM CLEARANCE
38-1/2"
36-1/2"
29-1/2"
12-1/16"
2"
7"
3-3/4"
1-1/4"
12-1/16"
5-3/4"
16"
24-1/8"
16"
24-1/8"
24-1/8"
16"
8-1/8"
1" MINIMUM CLEARANCE
Dimensional Information
Mechanicals
5400 North Michigan Road • Saginaw, MI • 48604-9780
989.752.4275 • 800.748.0423 • Fax 989.752.4444
www.glastender.com
Printed in USA
Loading...