GS08 - TOUCH SWITCH USER MANUAL
WARNINGS
•
While removing your Touch Switch from your
GlassOuse or other devices, pay attention not
to damage the wire joining points both on the
3.5mm jack connector and the Touch Switch
module parts.
•
To change the battery, remove the tiny screws
at the bottom. Pay attention to the + and – pole
remarks of the battery box during installation.
•
Keep Touch Switch away from magnets.
TOUCH SWITCH
With an 8.63cm activation surface, Touch Switch is highly
sensitive to detect slight touches on activation area without
any delay. Simply touch any area on the switch module to
perform your clicks including the edges of the device. GS08
Touch Switch comes with a 3.5mm mono jack connector
plug and it is compatible with any kind of adapted devices
besides GlassOuse V1.2 and higher.
Touch Switch works with 3x AAA dry or Ni-MH batteries and
its smart battery system turns the device off in one hour if it
is not used. Auditory and visual feedback can be selected
according to the user’s needs easily or can be turned off if
desired. With the help of the external secondary switch, you
can extend the using range of Touch Switch with a smaller
activation module.
FEEDBACK SIGNALS
USER MANUAL
You can set the click feedback according to your needs. Use the tiny power button on the switch module for the
desired feedback type as following. A second of press is enough to change the feedback mode.
1. Press the power button once – only visual LED feedback on without any auditory sound.
2. Press the power button once again – only auditory sound feedback on without no LED.
3. Press the power button once again – both visual LED and auditory sound feedback together.
4. Press the power button once again – no visual LED or auditory sound feedback.
EXTERNAL SECONDARY SWITCH
You can combine your Touch Switch with a tiny and more portable option to extend the using range. Simply plug
the secondary switch and place it according to your needs.
SWITCH CONNECTION
1. Plug Touch Switch to Glassouse V1.2 or any 3.5mm jack adapted device via 3.5mm connector.
2. Adjust the position of Touch Switch until you feel comfortable enough to touch the switch.
3.
Press the power button on your switch for 3 seconds to activate Touch Switch. The LED light will flash with
beep sound. Press the power button again for 3 seconds to turn off your Touch Switch. The LED light will flash
with beep to indicate that the switch is turned off.
GS08 - TOUCH SWITCH
Dimensions: Diameter: 96.9mm x Thickness: 28.55mm
Weight: 125±2g
Cable Length: 185±5cm
Activation Surface: 86.30mm
Battery Type: 3x AAA Dry or Ni-MH Batteries
DEVICE
ACTIVATION SURFACE
JACK PLUG-IN
FEEDBACK/POWER
BUTTON
3.5MM JACK CABLE
Loading...