Glasdon PEMBRIDGE Instruction Manual

PEMBRIDGE™ PICNIC TABLE

INSTRUCTIONS MANUAL

IMPORTANT NOTE: ENSURE THAT ALL RELEVANT PERSONNEL READ THESE INSTRUCTIONS PRIOR TO USE

KIT CONTENTS:

ITEM 1 - Crossbar and Leg Assembly x 1
ITEM 2 - Seat Assembly x 2
ITEM 3 - Support Blocks x 4
ITEM 4 - Coach Bolt - M10 x 180mm x 2
ITEM 5 - Washer - M12 x Ø23mm x 10
ITEM 6 - Nyloc Nut - M10 x 10
ITEM 7 - Domed Tamper Resistant Cover Cap x 4
ITEM 8 - Tamper Resistant Cover Cap x 8
ITEM 9 - Hex Head Bolt - M10 x 130mm x 8

EQUIPMENT REQUIRED:

- Cordless Drill or Philips Screwdriver x 1

- 17mm Socket Wrench x 2

- Mallet x 1

3

2

1

4

5

6

7

8

9

Please also refer to the ‘Manual Handling Operations Regulations 1992’ during the handling of the product

and materials used for installation. Glasdon recommends that a full Health and Safety analysis is carried out

prior to installation.

Table Pack

WHEELCHAIR ACCESS MODEL

ASSEMBLY INSTRUCTIONS

1. Carefully remove packaging from the table and pallet.

2. Using the hand drill or screwdriver unscrew the xings holding the timber blocks supporting the
seat assemblies during transit. Remove the 2 x wingnuts holding the table legs to the pallet.

2 of 12

3. Carefully remove the crossbar and leg assembly (Item 1), seat assemblies (Item 2), support blocks
(Item 3) and xing pack from the pallet.

IMPORTANT :

If manually moving the table pack we strongly recommend that for the Enviropol® model a
minimum of ve people manoeuvre the table into position. For the Timberpol® model we
recommend six people.

4. Carefully manoeuvre the picnic table to the desired location by lifting the table from the positions
marked in the illustration above.

3 of 12

1

2

3

5. Place 4 x support blocks (Item 3) between the tted crossbar and the ground directly beneath the
halving joint.

6. Feed the crossbar and leg assembly (Item 1) through the table pack assembly and slot it into the
corresponding halving joints of the tted lower crossbar. Take care to orientate the crossbar and leg
assembly the correctly with the halving joints facing the downward.

4 of 12