Glasdon LOWTHER SEAT Installation Instructions Manual
1.
LOWTHER SEAT
INSTALLATION INSTRUCTIONS
IMPORTANT NOTE: ENSURE THAT ALL RELEVANT PERSONNEL READ THESE INSTRUCTIONS PRIOR TO USE
MINIMUM BASE REQUIREMENTS :
If no suitable existing base, then base
to be sized as per drawing illustration
x 200mm thick concrete onto well
consolidated hardcore.
Base to be smooth (oat nish), at
level and square and preferably ush
with surrounding ground level.
FULL BASE SLAB OPTION
650mm
2061mm
INSTRUCTIONS FOR NEW CONCRETE FOUNDATION
IMPORTANT NOTE: ENSURE THAT ALL RELEVANT PERSONNEL READ THESE INSTRUCTIONS PRIOR TO USE
™
INDIVIDUAL PAD OPTION
650mm
2061mm
300mm 300mm
1761mm
(pad centres)
C
L
C
L
2.
INSTRUCTIONS FOR CONCRETE FIXING KIT
(INTO PREPARED CONCRETE FOUNDATION)
Seat Base
Tamper - resistant cap
M10 x 100mm hex head screw
M10 x 25mm washer
Anchor sleeve
120 -140mm
Concrete base
1. Place seat in desired position onto the concrete
foundation and mark all four hole positions through
seat ends with drill tip.
2. Remove the seat and drill marked holes depth of
120-140mm using a 12mm diameter masonry drill.
3. Ensure holes are free from any obstructions and
debris caused by drilling.
4. Ensure washers are in position at the top of the bolts
supplied.
5. Reposition seat so that the base holes are aligned
with drilled holes and insert four xings using a hammer.
6. Tighten up the nuts with 17mm socket until tight
(maximum recommended torque setting is 40Nm).
7. Place one armouring over each xing head. Use
cardboard over amouring and tap on with a hammer.
Ensure that a washer is used beneath each nut as
otherwise removal at a later date will be impossible.
To remove, prise armouring off with a screw driver.
IMPORTANT NOTE: ENSURE THAT ALL RELEVANT PERSONNEL READ THESE INSTRUCTIONS PRIOR TO USE
DISTANCE FROM THE EDGE OF FOUNDATION TO CENTRE OF GROUND BOLT TO BE
NO LESS THAN 100MM.
Note: Concrete xing kit and anti-tamper armourings are supplied as standard with every seat.
Loading...