Gladwork LM401 Instruction Manual

1

use cold lamination if you just finish the job of hot lamination. When Ready
LED turns on in green, put the paper into cold pouch, and insert the pouch
into laminator through Lamination Entry.

HOT LAMINATION
If you press the switch button to "Hot" position, you would have to wait for
about 5 minutes until the Green Ready LED turns on , and then put the
paper into pouch, and insert the pouch into laminator through Lamination
Entry.

CLEAR THE JAMMED POUCH

This laminator is designed with a manual release device to clear the jammed
pouch. When a misfeed or jam occurs, press down "ABS" button and pull
out the jammed pouch.

MAINTENANCE AND WARNING

1. When laminating an important document always do a test pouch (with
blank document) first.

2. To clean laminator exterior ensure the laminator is unplugged and cool.
Use a damp cloth with water. Avoid detergents and solvents.

3. Do not use this laminator in damp conditions.

4. Do not laminate anything that is more than 0.6mm thickness for best seal.

5. Do not laminate heat sensitive paper.

6. Do not insert open side of pouch into lamination entry, it may lead to
jamming or curling inside.

WARRANTY

See ‘Warranties Against Defects’ insert sheet for more information.

GBC Splash A4 Laminator

Instruction Manual

Model: LM401

Please read this manual carefully before use to ensure you get the best
results out of your machine.

Thank you for buying this GBC SPLASH laminator! This laminator features
a slim, compact and colourful design. It accepts pouches ranging from
75Mic to 125Mic up to A4 in size.

2

PRODUCT DESCRIPTION

SPECIFICATION

Voltage:

220-240V/50Hz

Current:

1.0 A

Ready time:

5 Min/80Mic

Entry width:

235 mm

Thickness:

0.6 mm

Pouch:

Cold/75/~125 Mic

speed:

250mm/Min

Rollers:

2

Size:

380 x 105 x 47 mm

N.W.:

1.0 Kg

SAFETY NOTES

1. This laminator should be horizontally displayed in a flat surface with
good ventilation. Warning: the laminator housing will become hot when in
operation – this is normal for the hot lamination process but please take
caution.

2. Never leave the laminator unattended when turned on and always turns

laminator off after use.

3. This laminator should only use power 220-240V/50Hz and be used
indoors only.

4. This laminator is for home and office use only.

5. Don’t laminate empty pouches and only use this laminator for its intended
use of laminating documents.

6. NEVER OPEN THIS LAMINATOR WHILE IN USE & DO NOT
ATTEMPT TO SERVICE OR REPAIR THE LAMINTOR YOURSELF.

OPERATION

POWER ON and OFF
Connect the plug to mains power, press switch button to turn on the machine.
The Power LED would turn into Red. If you press switch button to "Cold"
position, the machine is under cold lamination status. If you press switch to
"Hot" position, the machine is under hot lamination status.

To turn off this laminator, press switch button back to "Off" position, power
will be cut off and laminator is shut off.

Entry

LED

Switch Button
ABS Button