
INSTALLATION INSTRUCTIONS
for JennAir Compactor Noir Panel Accessory
In many instances, customers want to integrate the undercounter
compactor appearance with overall kitchen design. Use the
materials in this accessory kit to install the panel by following the
installation instructions.
Before you begin:
A qualied service technician must perform installation.
Panel Accessory contains:
1 Front Panel and Handle Assembly
6 Screws — #8 x 3/8" Low Rd. Head
Tools required:
Phillips Screwdriver
Installation Procedure
1. Remove Drawer from Compactor by pulling out and lifting
up to remove. Set the drawer on protective surface such as
cardboard, to protect the customer’s oor.
2. If your Compactor currently has a front panel and handle,
remove the assembly by removing the 6 screws holding the
front panel to drawer. Then lift the front panel and handle
assembly upward and OFF.
3. Slide new front panel assembly on drawer from the top. Use
the six (6) mounting screws supplied to mount the front panel
assembly. See Figure 1.
Front panel and
Handle assembly
Figure 1
4. Install drawer assembly in compactor.
Instruction Sheet W11238357A 05/18